Publicidad
2.0
Fuse
Fuse
5A
15A
Relé
Gas Pressure
Temperature
Gas
Inlet
LPG EV
WARNING:
- Follow carefully petrol and gas injectors sequence as shown in the diagram.
- Never connect front and back Solenoid Valve cables to the Ground.
- In order to make a front and back Solenoid Valve right diagnostic, don't connect them to each other.
- Never replace fuses with another ones with bigger amperage.
CAUTION:
Be careful with the cars for which the manufacturer prohibits or advises against disconnecting the battery, not to alter the antitheft devices or automatic adaptivity -
Never use welders connected to the battery of the same car - Connect with suitably insulated soft solderings - Position the BRC electrical devices in a well ventilated
area, protected from water seepages and heat sources - We recommend to insulate the BRC electronic control unit wires which are not connected - BRC reserves the
right to modify this diagram without notice - We also recommend you to be sure to have the last revision of the diagram drawn up by BRC.
M.T.M. Srl
SEQUENT DIRECT INJECTION 2.0
Qashqai 1.2 16V
Multipoint Electronic Injection
Changeover
Switch
Cut and
Insulate
Singularly
1
2
3
4
and
Sensor
Gas Injectors Sequence
Wiring diagram
(HRA2) 85kW
Euro 5b START & STOP
Diagnostic
Point
3
2
1
Connect
to positive
petrol
injecto r
Pin n° 1D Conn. Small black
Cut and
Pin n° 3A Conn.
Insulate
Singularly
Pin n° 4A Conn.
Pin n° A3 Conn. Big black
Pin n° H3 Conn. Small black
Pin n° 1Q Conn. Grey (1° Injector Signal)
Pin n° 1P Conn. Grey (1° Injector Positive)
Pin n° 3Q Conn. Grey (2° Injector Signal)
Pin n° 3P Conn. Grey (2° Injector Positive)
Pin n° 2Q Conn. Grey (3° Injector Signal)
Pin n° 2P Conn. Grey (3° Injector Positive)
Pin n° 4Q Conn. Grey (4° Injector Signal)
Pin n° 4P Conn. Grey (4° Injector Positive)
Petrol
Injectors
Sequence
9|9
Date:
Diagram n°:
In place of diagran n°
Draftsman:
Signature:
Level sensor connector
Red
Cut and Insulate
Rear Solenoid Valve Connector
Black
Black
Black
Red
Red
+
-
Battery
Warning: CAN BUS connection
can NOT be made on diagnostic
socket level, but it MUST be made
on petrol ECU connector level.
Small black
Small black
Pin n° 2B
Conn. Grey
White (MAP Signal)
Map
Sensor
DO NOT CONNECT
30_01_15
1
//.//.//
I.C.
fusibili
Petrol
ECU
MV
FSG000038R
Publicidad
