Jimmy JV83 pro Manual De Instrucciones página 11

Cleaning and Replacing Parts
Attention:
1.HEPA filter is available for sale from local
vacuum cleaner distributors.
2.It is recommended to clean the dust cup after
each use; When the dust cup is full or the
HEPA filter is clogged, it needs to be cleaned
and replaced if necessary.
3.Electric floor head brushroll might be entangled
with hair after long time use. It needs to be
cleaned in time to keep the vacuum working
more efficiently.
Clean dust cup and filtration system
When dust cup is full or HEPA is clogged, LED
screen will display HEPA icon as the picture to
remind to clean dust cup and filter. Please clean
dust cup and HEPA filer in time. Replace HEPA
filter if necessary.(Fig 11)
Steps of cleaning dust cup and filtration
system:
1.Press dust cup bottom cover release button,
open dust cup bottom cover, dump dust into
trash can.(Fig 12)
2.Lift up HEPA lid assembly from dust cup.
Rotate HEPA filter clockwise and remove it
from HEPA lid for washing. After washing, HEPA
need to be completely dry before using it again.
(Fig 13)(Fig 14)
3.Push dust cup release button located behind
the dust cup and remove dust cup. Hold cyclone
assembly handle and pull it out of dust cup.
Disassemble cyclone top, secondary dust cup,
adjustment ring and inner cyclone in sequence
for cleaning. After washing, all parts need to be
completely dry before using again. After cleaning,
assemble the parts back in the opposite
sequence of disassembly.(Fig 15)(Fig16)
11
13
14
16
12
15
Dust cup release
button
9