Sima STAR-16 GO Manual De Instrucciones Original página 32

BAR SUPPORT: This is for convenience and speed of productivity.
BEND LENGTH MEASURER: The bar length measurer can be mounted on the left or right of the machine. There are
two measuring plates for adjusting length of bend.
BENDING SUPPORT (STAR-16 GO): The bending support is used for supporting multiple bars for the bend. The
STAR-16 GO stirrup bender only rotates clockwise, so the bending support must be mounted to the left of the bending
plate as shown in the figure. To distance the bending square according to the bar that we use, we must loosen the screw
and slide it over the slot. To reposition the bending support according to the bar that we use, loosen the screw and slide
the support along.
9
ENGLISH