Publicidad
Idiomas disponibles
Idiomas disponibles
7. GETTING STARTED.
WARNING: All safety recommendations must be followed, either the ones mentioned in the present user
manual or those complying with all labour risks prevention norms in every location.
WHEELWORK: SIMA bending and combined machines do not need any wheelwork operations as they are
specially designed to obtain the maximum performance from start.
NORMAL USE OF THE MACHINE:
The bending machines have been designed for bending flat and reinforced steel bars for use in the structure
and other construction components
Any tool or accessory added or amended without written authorization from the manufacturer is considered inappropriate
and dangerous. If any damage or injury is caused as a result thereof or by misuse of the machine, SIMA S.A. exempts
all responsibility as manufacturer. The machine must be installed on a plane, firm and horizontal surface and the ground
should not be soft.
This machine MUST NOT BE USED IN THE RAIN. Cover with waterproof materials. If the machine has
been exposed in the rain check before connecting the electrical parts are not wet. Always work with
good lighting conditions.
7.1
CONNECTING TO THE SUPPLY.
The extension cable used to feed the machine needs to have a minimum section of 4x2.5 mm
long. For a superior distance 4x4 mm2 can be used. In one of its ends, it is needed to connect a base normalized aerial
of 3P+T or 3P+N+T compatible with the machine switch and in the other end, one normalized aerial pin of 3P+T ó
3P+N+T compatible with switchboard exit.
Machines with electrical motor should always be connected to a normalized switchboard
that disposes of a magneto-thermal switch and a differential in accordance with the characteristics
of the motor:
The machine electrical tension is visible on the voltage indication next to the top of engine terminals and on the
machine characteristics plate.
WARNING:
Do not plug the machine to the electricity if you are not sure of the available
electrical tension. If the tension is not correct, the engine will undergo irreparable harm or out of
service.
Don´t connect the machine unless you are sure of the stability of the electricity supply
Do not change any electrical configuration in the machine as this may result in irreparable damage
.
Each other use that has not been expressively indicated is considered abnormal.
12
2
up to 25 meters
TRANSFORMER
MOTOR
ENGLISH
Publicidad
