Maintaining your appliance
3.
Open the door fully. If the door will not open fully, the indentation is not
inserted correctly in the bottom edge of the slot.
4.
Push the hinge locks up against the front frame of the oven cavity to the
locked position.
5.
Close the oven door.
Removing and re-installing the storage drawer
Hook
Hook
40 English
NE59M4310_AA_DG68-00881A-03_EN+MES+CFR.indb 40
Hinge lock
Unlocked position
Locked position
How to remove the storage drawer
1.
Pull the drawer out until it stops.
2.
Tilt the front of the drawer and pull out
it until it stops.
3.
Lift and pull the drawer out.
How to re-install the storage drawer
1.
Put the left side of the drawer over the
left hook and the right side over the
right hook.
2.
Push the drawer until it stops.
Tilt and lift the drawer.
3.
4.
Push the drawer in.
Changing the oven light
The oven light is a standard 40-watt appliance bulb. It will come on when the oven
door is open. When the oven door is closed, press the
off.
1.
2.
Remove Replace
3.
4.
Glass bulb cover
Bulb
5.
6.
Before changing your oven light bulb,
disconnect the electrical power to the range
at the main fuse or circuit breaker panel.
Make sure the oven and the bulb are cool.
pad to turn it on or
Make sure the oven and the bulb are
cool.
Unplug the range or disconnect the
power.
Turn the glass bulb cover in the back of
the oven counterclockwise to remove.
Turn the bulb counterclockwise to
remove it from its socket.
Insert a new 40 watt appliance bulb,
and then turn it clockwise to tighten.
Replace the bulb cover by turning
clockwise.
Plug in the range or reconnect the
power.
CAUTION
2019-12-13
10:57:48