Lumina Products Aquafire AWA2-20-50 Instalación Uso Y Mantenimiento página 15

5. Installation diagrams
AFIRE devices are meant to be embedded without needing any ventilation in the housing for the device.
obstruct the air inlets located on the top of the device.
In the housing, you must install a normal 110/240 volt (12 amp) electric current in order to power the device
through a 24-volt transformer.
You must also install water supply if you want to connect your device directly.
outside the recess in order to be able to close the water supply if necessary (drainage, etc.)
See the diagram below for the embedding dimensions.
You must leave 5 cm minimum around the device to facilitate installation.
Do not obstruct the air inlets located on the top of the device.
Embedding dimensions
References
AWPR2 20-50
AWPR2 40-100
AWPR2 60-150
AWA2 20-50
AWA2 40-100
AWA2 60-150
A Length
514mm(20.24in)
1022mm(40.24in)
1530mm(60.24in)
514mm(20.24in)
1022mm(40.24in)
1530mm(60.24in)
www.a-fireplace.com
This water arrival must include a tap
B Width
309mm(12.17in)
309mm(12.17in)
309mm(12.17in)
309mm(12.17in)
309mm(12.17in)
309mm(12.17in)
Do not
C Depth
346mm(13.62in)
346mm(13.62in)
346mm(13.62in)
280mm(11.02in)
280mm(11.02in)
280mm(11.02in)
14