Lumina Products Aquafire AWA2-20-50 Instalación Uso Y Mantenimiento página 17

The ON/OFF button turns the device on and off. Button B1 is used to fill the reservoir with water. Button B2
is used to empty the device. Hold the button for 5 seconds to start the pumps. Press once to stop the
AWA2 without draining button.
pumps. The stainless-steel "Tube" connection connects to the plastic
hose provided to fill and empty the device.
ATTENTION: The water used must be perfectly clean with no dust or reside that may clog the
hydraulic system. This point is very important for the operation of your device.
B. Using your device for the first time
Depending on your type of device (AWPR2), it may be connected directly to your home's water network (see
diagram below, ¼" ). In this case, if you press the ON/OFF button and the isoalation tap on the hydraulic
circuit is open, the device will fill automatically. In all cases, if you do not use your device, shut off the
income water supply to avoid leaking.
If the device is not connected to the water network, you can fill the reservoir using button B1 (fill). To do so, first,
connect the provided hose to the stainless-steel connector (tube) and submerge the mart of the hose with its
filter in a container of water. Then, press the ON/OFF button. The row of orange LEDs will blink immediately
(empty reservoir). Then, press B1 during 5 seconds once and the filling pump will start and stop automatically
when the reservoir is full. The orange LEDs will remain on and vapor will start to come out of your device. Note:
for the first filling, you will need: 2 liters for AWA2 20-50 and AWPR2 20-50, 4 liters for AWA2 40-100, AWPR2
40-100, 6.5 liters for AWA2 60-150 and AWPR2 60-150. Then, you can control your device using the remote
control or the App.If your device is an ADVANCE AWA2, use Button B1 to fill water.
C. Caution
Tap water may be used in our devices, however, be sure the water is not considered to be "hard" and that
it contains no impurities (may clog valves). If your water is hard, you must use filtered or softened water in
order not to wear out the Mist Maker too quickly.
¼"
Direct connection to the water network
www.a-fireplace.com
16