Lumina Products Aquafire AWA2-20-50 Instalación Uso Y Mantenimiento página 18

D. Using the device
AFIRE devices have several control possibilities.
1. Manual (On/Off button)
2. Via radio remote control
The remote control is paired with your device in the factory. However, if you want to change your remote
control, you must install the new one onto your device (device in OFF position). Just press and hold the
ON/OFF button for 5 seconds. The ON/OFF button will start to blink. Then, simply press any button on the
remote control. You will hear a confirmation beep, and the remote control will be paired to the module.
Buttons on your remote control:
On/Off: Turns the device on or off. Attention: the ON/OFF button on the device must be switched on.
Orange On/Off Orange: The row of orange LEDs can be switched on or off.
RGB On/Off: Starts or stops the RGB lights.
Flame height: Increases or decreases the height of the flame. With each change of height, the device will
beep. At the maximum and minimum settings, the device will no longer beep. There are 5 settings possible.
Flame speed: Changes the speed of the flames. At the maximum and minimum settings, the device will no
longer beep. There are 5 settings possible.
Brightness: Changes the Brightness of the lights. At the maximum and minimum settings, the device will no
longer beep. There are 5 settings possible.
Color change: FADE: 15 color circulation, fading to next color in 5 seconds.
AWO
17
AWA2
www.a-fireplace.com
AWPR2