Whirlpool WHISPURE AP450 Manual De Uso Y Cuidado página 5

Cleaning
G
A. Release tabs
B. Control knob
C. Mainframe assembly
1. Turn the control knob to Off.
2. Unplug air purifier or disconnect power.
3. Place fingers on the front release tabs. Gently push the tabs
in and pull the front grille forward to remove it.
4. Remove both filters and set aside. Do not try to wash and
reuse either the HEPA filter or the pre-filter.
5. Clean the air purifier with a soft, damp cloth.
6. Gently wash the front grille in soapy water.
NOTE: The grille is not dishwasher safe.
7. Reassemble the filters as shown in the previous illustration.
8. Place the bottom tabs on the front grille into the slots in the
base of the air purifier. Push the top of the grille forward until
the grille locks into place.
9. Plug in air purifier or reconnect power.
10. Turn the control knob to the desired fan speed.
First try the solutions suggested here and possibly avoid the cost of a service call...
Air purifier will not run
Check the following:
Is the air purifier turned on?
AIR PURIFIER CARE
B
A
A
E C
F D
D. Bottom slot F. Pre-filter
E. HEPA filter G. Front grille
TROUBLESHOOTING
Get other manuals https://www.bkmanuals.com
Filter Replacement
NOTE: The filter indicator lights on top of the air purifier will glow
when it is time to replace either the pre-filter or the HEPA filter.
For the most efficient operation of the air purifier, under normal
conditions it is recommended that you replace the pre-filter every
3 months and the HEPA filter every year. See "Replacement
Filters" in the "Assistance or Service" section.
1. Turn the control knob to Off.
2. Unplug air purifier or disconnect power.
3. Place fingers on the front release tabs. Gently push the tabs
in and pull the front grille forward to remove it.
4. Remove and replace the indicated filter. Install the new HEPA
filter in the same direction shown by the arrow located on the
filter frame. Install the new pre-filter by placing it on the tabs.
NOTE: Do not try to wash and reuse either the HEPA filter or
the pre-filter.
5. Place the bottom tabs on the front grille into the slots in the
base of the air purifier. Push the top of the grille forward until
the grille locks into place.
6. Plug in air purifier or reconnect power.
7. Turn the control knob to the desired fan speed.
8. Press the Filter Reset button for 5 seconds to turn off the filter
indicator light(s) and reset the timer.
NOTES:
Pressing the Filter Reset button before either of the filter
indicator lights glows will not reset the timer.
Use of a non-Whirlpool filter or failure to replace the filter
regularly will invalidate this warranty.
Is the power cord plugged into a grounded 3 prong outlet?
Has a household fuse blown, or has a circuit breaker tripped?
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
Was a regular fuse used? Use a time-delay fuse or time-delay
circuit breaker.
5