Replacing The Light Bulb; Troubleshooting - Hotpoint Ariston FH 103 0 IX/HA Manual De Instrucciones

and cause the glass to crack. For more thorough cleaning purposes, the oven
door may be removed:
1. Open the oven door fully (see diagram);
2. Lift up and turn the small levers located on the two hinges (see diagram);
Grip the door on the two external sides
and close it approximately half way.Pull the
door towards you lifting it out of its seat (see
diagram).
To replace the door, reverse this sequence.
Inspecting the seals
Check the door seals around the oven regularly. If the seals are damaged,
please contact your nearest Service Centre (see Assistance). We recommend
that the oven is not used until the seals have been replaced.

Replacing the light bulb

! Do not use the oven lamp as/for ambient lighting.

Troubleshooting

Problem
The "Clock button" and the digits on the
display flash.
A programmed cooking mode does not
start.
Only the high luminosity "Clock button"
is lit.
An automatic mode has been selected.
"Hot" appears on the display and
cooking does not start.
Fan-assisted cooking has been
selected and the food looks burnt.
To replace the oven light bulb:
1. Remove the glass cover of the
lamp-holder.
2. Remove the light bulb and replace
it with a similar one: Wattage 25 W,
cap E 14.
3. Replace the glass cover (see
diagram).
Possible cause
The appliance has just been connected to the
electricity mains or there has been a blackout.
There has been a blackout.
The appliance is in standby mode.
The temperature inside the oven is higher
than the suggested value for the selected
mode.
Positions 1 and 5: the direct heat could cause
temperature-sensitive foods to burn.
Solution
Set the clock.
Reprogram the cooking mode.
Press any button to exit standby mode.
Wait for the oven to cool down.
We recommend switching dripping pan
positions halfway through cooking.
GB
29