Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the water lines
An automatic ice maker is a very useful
feature in your new refrigerator. Please
follow the below instructions carefully
for correct installation.
In order for the ice maker to operate
properly, a water line is required.
-the maximum inlet water pressure is 700kPa;
-the minimum inlet water pressure is 207kPa.
WARNING!
The water connection must be made
by a qualified plumber. Operation
outside the water pressure range
may cause
malfunction, or
and damaging water leaks.
Under normal conditions, a200cc
(5.75 oz.) cup can be filled in about
10 seconds.
If the refrigerator is installed in an area
with low water pressure (below 30psi),
you can install a booster pump to
compensate for the low pressure.
What you need to have before you
1. Power drill and 1/4'' drill bit.
2. 1/2'' or adjustable wrench.
3. Flatblade and Philips head screwdrivers.
Saddle-type
Shut offvalve
compression
(1/4" outlet)
1/4" extension
tubing
4. You may need to purchase several
items to complete this connection.
You may find these items sold as a kit
at a local hardware store.
severe
begin
one 1/4"
1 ferrule
(sleeve)
1 Coupler
2 Clips
Connecting to the water supply line
1.
First, shut off the main water supply.
2.
Using a power drill and a 1/4'' drill bit
drill into the cold-water line and
connect the saddle-type shutoff valve.
Cold water line
Pipe clamp
Shut off Valve
3.
Connect 1/4'' extension tubing to shutoff
valve outlet.
Saddle-Type
Shutoff Valve
Packing Nut
Outllet Valve
4.
Flush the tubing. Turn the main water
supply on and flush out the tubing until
the water is clear. Then, shut the water
off at the water valve after about a quart
of water has flushed through the tubing.
Compression Nut
1/4" Extension
tubing
Ferrule(sleeve)
7
Publicidad
