8.4.2
Mount the grass collection basket
(5) (Fig. 6)
WARNING
Danger of crushing!
Pay attention to your fingers!
• Wear gloves.
1. Clip both parts of the grass collection bag (5) to-
gether.
9
Pre-commissioning
NOTE
Some noise pollution from this product is
unavoidable. Postpone noisy work to ap-
proved and designated times. If necessary,
adhere to rest periods and limit the dura-
tion of work to the bare minimum.
For your personal protection and the pro-
tection of nearby persons, wear suitable
hearing protection.
9.1
Setting the cutting height
ATTENTION
The cutting height may only be adjusted
when the engine is shut off.
WARNING
Danger of injury!
To switch off the product, switch off the motor, wait
for it to stop, remove the battery and pull out the safe-
ty key.
• In dense, tall grass, set the highest cutting level and
mow more slowly. A high cutting height should be
selected for the first cut of the season. Adjust the
cutting height so that the product is not overloaded.
• Set the cutting height depending on the actual
length of the lawn.
• Carry out several passes so that a maximum of 4
cm of lawn is removed at a time.
The cutting height is adjusted via the front and rear ax-
les.
WARNING
Danger of crushing!
Pay attention to your fingers!
30 | GB
3 different cutting heights can be set:
1 =
2 =
3 =
1. Lay the lawnmower on its side.
2. Start by gripping the sides of the rear wheel axle
with both hands.
3. Then pull evenly on the wheel axle and allow it to
latch into the desired position.
4. Repeat the process on the front wheel axle.
Note:
Set the wheel axles to the same cutting height.
9.2
Inserting/removing the battery
(12) in the battery mount (Fig. 1,
7)
Inserting the battery
1. Open the cover (6).
2. Push the battery (12) into the battery mount (13).
The battery (12) clicks into place audibly.
3. Close the cover (6).
Removing the battery
1. Open the cover (6).
2. Press the unlock button (14) of the battery (12) and
remove it from the battery mount (13).
3. Close the cover (6).
9.3
Preparing the area to be mowed
1. Before mowing, carefully examine the area.
2. Remove stones, sticks, bones, wires, toys and other
objects that may be ejected by the product.
3. Ensure that no other people are present on the sur-
face to be mowed.
10 Operation
The battery-powered lawnmower has a cutting tool that
rotates parallel to the cutting plane. It is equipped with a
powerful and quiet-running electric motor, a robust
housing, a safety bar, a safety key, a double-sided lawn
edge intake and a grass collection bag. The product al-
so has smooth-running wheels. Please refer to the fol-
lowing descriptions for the function of the controls.
WARNING
Danger of injury!
Remove the battery from the power tool before carry-
ing out any work on the power tool (e.g. maintenance,
tool change, etc.) and when transporting and storing
it. There is a risk of injury if the on/off switch is oper-
ated unintentionally.
www.scheppach.com
20 mm
45 mm
60 mm