Descargar Imprimir esta página

PYD Electrobombas SWITCHMATIC 1 Serie Manual De Instalación Y Mantenimiento página 22

Controlador eléctrico

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING AND MAINTENANCE MANUAL
SWITCHMATIC SERIES CONTROLLER
SCALE BACKGROUND
1. Start the pump up to the cut-out pressure of the pressure switch.
2. Press the buttons
3. Set the pressure values with the push buttons
4. Press
to validate.
Note 5: Pressure sensor decalibration should not be a normal occurrence. If it occurs
repeatedly, contact service.
14. WARNINGS AND ALARMS
COD.
DESCRIPTION
www.proindecsa.com / proindecsa@proindecsa.com
and
simultaneously until the display flashes.
If a lack of water is detected, the appliance stops.
the appliance stops. Operation is resumed by
pressing by pressing ENTER.
When a lack of water is detected with the
Automatic Reset System (ART) is activated.
on, the first attempt is made after 5 minutes and
minutes and then an attempt every 30 minutes
30 minutes for 24 hours. This alarm can also be
reset manually manually with the ENTER button.
If the system persists after 24 hours, there is a
definite lack of water.
Appears if in normal operation the pressure is
below the minimum pressure (Px.x) previously
(Px.x) previously set for the time (txx) previously
set in the time (txx) previously set in the ADVAN-
CED MENU. If at any time the pressure exceeds
the minimum pressure, operation is automatically
is automatically restored.Normal operation can
also be restored can also be restored manually by
pressing ENTER.
An overcurrent alarm occurs if the rated current
of the pump is exceeded.
4 automatic reset attempts are made attempts
are made before proceeding to the final alarm.
final alarm. Normal operation can also be resto-
red can also be restored manually by pressing
ENTER.
to indicate the desired pressure.
SYSTEM REACTION
22

Publicidad

loading

Este manual también es adecuado para:

Switchmatic 2 serie