Nexx X-COM 3 Pro Guia Del Usuario página 54

13.2.16 Voice Prompt (Default: Enable)
While some Voice Prompts may be disabled in the software configuration
settings, the following voice prompts are always on:
- Battery level indicator
- Speed dial
- FM radio functions
- Mesh Intercom
13.2.17 RDS AF Setting (Default: Disable)
A radio station with more than one frequency can be used by enabling
the Radio Data System (RDS) Alternative Frequency (AF) Setting. This
setting allows a receiver to re-tune to the second frequency location when
the first signal becomes too weak.
13.2.18 FM Station Guide (Default: Enable)
When FM Station Guide is enabled, FM station frequencies are given by
voice prompts as you select preset stations.
13.2.19 Advanced Noise Control™ (Default: Enable)
When Advanced Noise Control is enabled, the background noise
is reduced during an intercom conversation. When it is disabled, the
background noise is mixed with your voice during intercom.
13.2.20 Region Selection
When using the region setting, you can optimize the seek function to
avoid unnecessary frequency ranges, allowing you to select the proper FM
frequency range for your location.
Region
Worldwide
North America,
South America and Australia
Asia and Europe
Japan
X.COM3 - MOTORCYCLE BLUETOOTH COMMUNICATION SYSTEM WITH MESH INTERCOM
Frequency range
76.0 ~ 108.0 MHz
87.5 ~ 107.9 MHz
87.5 ~ 108.0 MHz
76.0 ~ 95.0 MHz
Step
± 100 kHz
± 200 kHz
± 100 kHz
± 100 kHz
54