Publicidad
Idiomas disponibles
Idiomas disponibles
3. Remove fuse carefully by using a small screwdriver to pry the fuse out of the compartment by the metal ends of
the fuse.
4. Place plug on a solid, flat surface. Insert new 2.5 Amp, 125 volt fuse into fuse compartment and use a small
screwdriver to secure the metal ends of the fuse into the compartment.
CAUTION: Risk of fire. Replace fuse only with 2.5 Amp, 125 volt fuse.
5. Slide fuse cover closed. If fuse cover is difficult to close, make sure fuse is secured in place by pressing down on
metal ends of the fuse.
6. Risk of fire. Do not replace attachment plug. Contains a safety device (fuse) that should not be removed. Discard
product if the attachment plug is damaged.
DO NOT OPERATE APPLIANCE IF THE LINE CORD SHOWS ANY DAMAGE OR IF APPLIANCE WORKS
INTERMITTENTLY OR STOPS WORKING ENTIRELY.
IMPORTANT: During the first few minutes of initial use, you may notice a slight odor. This is normal and will quickly
disappear.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list. If
any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 10 minutes.
No Tools Required for Assembly.
ASSEMBLY INSTRUCTIONS
1. Check if the arrows at the bottom of the Base Cover (K)
and the Pillar (J) area aligning. If so, insert the Pillar (J)
into the Base Cover (K) by aligning the holes. Push the
pillar into the base cover to snap and lock both together
tightly into place.
2. Remove the Blade Knob ( C ) from the Motor Housing (G). Then
remove the Rear Grille Mounting Nut (E) from the Motor Housing (G).
3. Place the Rear Grille (F) onto the Motor Housing (G), making sure the handle
on the Rear Grille is upward. Tighten the Rear Grille Mounting Nut (E).
1
4
L
J
K
2
G
E
C
3
F
E
G
Publicidad
