Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
4. Push the Fan Blade (D) onto the motor shaft, lining up the blade with
the iron pin on the motor shaft's end. Tighten the Blade Knob (C) .
5. Mount the Front Grille (A) to the Rear Grille (F) by positioning the Grille
Clips (B) on the Front Grille over the Real Grille. Secure the two grilles with
the Grille Clips attached the Front Grille.
CAUTION: TO AVOID THE RISK OF PERSONAL INJURY, MAKE SURE THE
FRONT GRILLE AND REAR GRILLE ARE FIXED WELL BEFORE OPERATING.
OPERATING INSTRUCTIONS
Controlling the Fan Speed
Once fan is fully assembled (see Assembly Instructions section), place fan on a dry, level surface. Plug it into a 120V AC
electrical outlet. To select the desired speed press the Speed Control Button on the Control Panel.
3 speeds control: 0=Off, 1=Low, 2=Medium, 3=High.
Controlling the Fan Oscillation
To oscillate the fan head horizontally (left to right), push down the Oscillation Control Knob located on the top of the Motor
Housing. To stop fan from horizontal oscillation, pull up the Oscillation Knob.
Adjusting the tilt of the fan head
To adjust the tilt of the fan head to the desired angle, push gently up or down on the fan grilles while holding the fan by the
motor assembly/control panel.
CAUTION: The fan should be switched off before making this adjustment.
CARE AND MAINTENANCE
This appliance requires little maintenance and contains no user serviceable parts. Do not try to fix it yourself. Refer it to
qualified service personnel if servicing is needed.
This fan is permanently lubricated and will not require additional lubrication for the life of the fan.
TO CLEAN: Before cleaning, turn fan off and unplug from electrical outlet. Wipe off excess dust with a lint-free cloth. To
ensure adequate air circulation to the motor, keep vents located at the rear of the motor housing free from dust
accumulation. A vacuum cleaner hose can be used to clean these vents. Do not submerge your fan in water or any other
liquid. Disassemble grilles and blade. Grilles and blade may be cleaned with mild soap and water. Use a soft, slightly damp
cloth to wipe the remaining fan parts. Do not allow water or any other liquid to get into the motor housing or base.
Reassemble fan after grilles and blade have dried completely. Do not plug fan into electrical outlet until it has been fully
reassembled.
TO STORE: Make sure to disassemble and clean the fan before storing. Retain the original packaging for the purpose of
storing your fan. Always store fan in a dry place. Never store it while it is still plugged in. Never wrap the cord tightly around
the fan, and do not put any stress on the cord where it enters the fan, as it could cause the cord to fray and break.
5
4
D
C
5
F
A
F
B
Publicidad
