LF UTILITECH ASF-400 Manual Del Usuario página 5

ASSEMBLY INSTRUCTIONS
2. Turn the assembled parts from the previous assembly step upside down. Place
the Base(Q) on the floor.
a. Loosen the Height Adjustment Knob (O) from the Lower Pole (P).
b. Extend the Upper Pole (N) to the desired height. Tighten the Height
Adjustment Knob (O) again.
c. Remove the Motor Bracket Locking Screw (M) and the Motor Bracket Locking
Knob (U) from the Upper Pole (N).
3. Remove the Tilt Adjustment Knob (L) and the Tilt Adjustment Screw (V) from
the Motor Bracket (F).
4. Place the Motor Bracket (F) on the Upper Pole (N).
a. Insert the Motor Bracket Locking Screw (M) into the square hole of the Motor
Bracket (F) and insert it through the Upper Pole (N).
b. Insert the Tilt Adjustment Screw (V) on the Motor Bracket (F) and insert it
through the hole in the Upper Pole (N).
c. Insert the Tilt Adjustment Knob (L) into the Motor Bracket (F), press and screw
the Tilt Adjustment Knob (L) against the surface provided on the Upper Pole (N)
for the purpose to set the fan head tilt angle.
5. Attach and tighten the Motor Bracket Locking Knob (U) to the Motor Bracket
Locking Screw (M).
6. Remove the 4 Rear Grille Screws (D) from the Motor Unit (J).
5
b.
N
c.
a.
O
P
U
F
V
b.
V
F
N
U
M
D
c.
N M
L
c.
L
a.
M
J