Classic Accessories 52-001-010401-00 Manual Del Usuario página 11

STEP 7
INSTALL ASSEMBLED CAB ON LOWER MOUNTING POSTS (FIG. 1)
ADJUSTING SNOW THROWER CAB ANGLE (FIG. 2)
CAUTION: No part of the fabric cab skin should touch the engine or exhaust system of your snow thrower.
PARTS NEEDED
1
Note: It may be necessary to loosen nuts on lower mounting posts [K] in order to slide
upper mounting posts [J] into position. Be sure to tighten both nuts after positioning.
Side of Snow Cab
shell pulled aside
for visibility
J
K
2
Loosen nuts on upper mounting posts [J] to adjust cab to proper angle
so that the mounting bar ends [C] are parallel to the ground.
11
TOOLS NEEDED
1/2 in. Box
Wrench
OR
Adjustable
Wrench
OR
1/2 in. Socket
Wrench
J