Publicidad
Idiomas disponibles
Idiomas disponibles
Start-up
follows:
• Open the Homematic IP app on
your smartphone.
• Select the menu item "Add device".
• Open the battery compartment (B)
by pulling the battery compartment
down
(see „Figure 2" on page 27).
• Remove the insulation strip from
the battery compartment. Pairing
mode remains activated for 3 mi-
nutes.
You can manually start the pairing
mode for another 3 minutes by
pressing the system button (D or
L) briefly.
Your device will automatically
appear in the Homematic IP app.
• To confirm, please enter the last
four digits of the device number
(SGTIN) in your app or scan the QR
code. Therefore, please see the
sticker supplied or attached to the
device.
• Please wait until pairing is comple-
ted.
• If pairing was successful, the LED
lights up green. The device is now
ready for use. If the LED lights up
red, please try again.
• Please select, in which application
(e.g. climate control) you would
like to use the device.
• In the app, give the device a name
and allocate it to a room.
6.2
Mounting
Please read this entire section
before starting the installation.
The radiator thermostat can be ins-
talled without draining heating water
or intervening in the heating system.
No special tools are required, nor does
the heating have to be switched off.
The union nut (A) attached to the radi-
ator thermostat can be used universally
and without accessories for all valves
with a thread size of M30 x 1.5 from the
most popular manufacturers such as
Heimeier, MNG, Junkers, Landis&Gyr
(Duodyr), Honeywell-Braukmann,
Oventrop, Schlösser, Comap, Valf Sa-
nayii, R.B.M, Jaga, Siemens or Idmar.
By means of the adapter in the deli-
very, the device can be installed also
on radiator valves of type Danfoss RA
(see „6.2.4 Danfoss RA adapter" on page
31).
6.2.1 Demounting the radiator
thermostat
We accept no liability for damage
to property or personal injury
caused by impoper use or failure
to observe the hazard warnings. In
such cases, all warranty claims are
void. We accept no liability for any
consequential damage.
Remove the old thermostat dial from
your radiator valve (see section 3, figu-
re 4).
• Rotate the thermostat dial to the
maximum value (N) (anti-clock-
wise). The thermostat dial then no
longer presses against the valve
spigot, making it easier to remove.
29
Publicidad
