Publicidad
Idiomas disponibles
Idiomas disponibles
Configuration menu of the radiator-thermostat
menu items.
Press and hold down the menu button
to get back to the previous level. The
menu automatically closes without ap-
plying changes if there is no operation
for more than 1 minute.
7.1
7.2
7.3
7.4
7.5
7.6
7.7
If you connect the device to the
Access Point, you can comfortably
adjust the settings via the
Homematic IP app.
If you have already adjusted the
settings in the configuration menu
or if you have already connected
the device to another
Homematic IP device, you first
have to restore the factory settings
of the device before you can con-
nect it to a Homematic IP Access
Point or another Central Control
Unit CCU3
(see „11 Restoring facto-
ry settings" on page
7.1
Automatic operation
In automatic mode, the temperature is
controlled in accordance with the set
heating profile. Manual changes are
activated until the next point at which
the profile changes. Afterwards, the
defined heating profile will be activated
again. To activate the automatic mode,
Automatic mode
Manual operation
Holiday mode
Operating lock
Programming a heat-
ing profile
Date and time
Offset temperature
39).
please proceed as follows:
• Select "Auto" via the plus and mi-
nus buttons (E and F) in the menu.
• Confirm with the menu button.
To confirm, the symbol flashes twice
and the device changes back to auto-
matic mode.
7.2
Manual operation
In manual mode, the temperature is
controlled in accordance with the
current temperature set via the push-
buttons (E and F). The temperature
remains activated until the next manual
change. To activate the manual mode,
please proceed as follows:
• Select "Manu" via the plus and mi-
nus buttons (E and F) in the menu.
• Confirm with the menu button.
To confirm, the symbol flashes twice
and the device changes back to manu-
al mode.
7.3
Offset temperature
As the temperature is measured on
the radiator thermostat, the tempera-
ture distribution can vary throughout a
room. To adjust this, a temperature off-
set of ±3.5 °C can be set. If a nominal
temperature of e.g. 20 °C is set but the
room presents with only 18 °C, an off-
set of -2.0 °C needs to be set. An offset
temperature of 0.0° is set in the factory
settings. To adjust the offset tempera-
ture, please proceed as follows:
• Select "Offset" via the plus and mi-
nus buttons (E and F) in the menu.
• Confirm with the menu button.
• Select the desired offset tempera-
ture using the plus or minus button
and confirm with the menu button.
34
Publicidad
