Publicidad
Idiomas disponibles
Idiomas disponibles
7
Unpacking
WARNING
The product and the packaging material are not
children's toys!
Do not let children play with plastic bags, films or
small parts! There is a danger of choking or suf-
focating!
• Open the packaging and carefully remove the prod-
uct.
• Remove the packaging material, as well as the
packaging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the product and accessory parts for transport
damage. Immediately report any damage to the
transport company that delivered the Product. Later
claims will not be recognised.
• If possible, keep the packaging until the expiry of
the warranty period.
• Familiarise yourself with the product by means of
the operating manual before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
• When ordering please provide our article number as
well as type and year of manufacture for the prod-
uct.
8
Before commissioning
8.1
Fitting the compressed air hose
(12) (Fig. 1)
1. Loosen the union nut (1) (do not loosen it complete-
ly).
2. Insert the connector (12c) of the compressed air
hose (12) into the mount.
3. Firmly retighten the union nut (1).
9
Operation
WARNING
Danger of injury!
Remove the battery from the power tool before carry-
ing out any work on the power tool (e.g. maintenance,
tool change, etc.) and when transporting and storing
it. There is a risk of injury if the on/off switch is oper-
ated unintentionally.
22 | GB
ATTENTION
The product is only suitable for continuous use. Use
the product for a maximum of 20 minutes. If the prod-
uct overheats, remove the battery immediately. Start
up the product again when it has cooled down.
ATTENTION
Make sure that the ambient temperature does not ex-
ceed 50°C and does not fall below -20°C during work.
ATTENTION
The product is part of the 20V gomag series and may
only be operated with batteries of this series. Batter-
ies may only be charged with battery chargers of this
series. Observe the manufacturer's instructions.
9.1
Selecting the valve adapter (Fig.
2)
Valve adapter:
Ball needle (13)
Universal valve
adapter (14)
Valve adapter for Dunlop/
flash valves (15)
Valve adapter for Sclaver-
and valves (16)
9.2
Inserting/removing the battery
(18) in the battery mount (9) (Fig.
3)
Inserting the battery
1. Push the battery (18) into the battery mount (9). The
battery (18) clicks into place audibly.
Removing the battery
1. Press the unlock button (17) of the battery (18) and
remove it from the battery mount (9).
9.3
Switching on/off
9.3.1
Variant 1
1. Press the on/off button (6) on the display (4) to
switch on the product. The display (4) shows the
preset pressure as described in Setting the pres-
sure.
2. Press the on/off switch (11). The product starts.
Note: The product switches off when the preset
pressure is reached.
3. To restart the product, press the on/off switch (11)
twice.
www.scheppach.com
Use for:
Balls
Air mattresses and similar
Bicycle tyres
Bicycle tyres
Switching on the product
Publicidad
