Braun wet & dry 7899cc Manual Del Usuario página 18

The cleaning cartridge also contains lubricants, which may leave residual marks on the
outer foil frame after cleaning. However, these marks can be removed easily by wiping
gently with a cloth or soft tissue paper.
Manual cleaning
Cleaning under running water:
• Switch the shaver on (cordless) and rinse the shaver head under hot running
water until all residues have been removed. You may use liquid soap without
abrasive substances. Rinse off all foam and let the shaver run for a few more
seconds.
• Next, switch off the shaver, press the release button (9) to remove the Foil & Cutter
cassette (8) and let it dry.
• If you regularly clean the shaver under water, then once a week apply a drop of light
machine oil (not included) on top of the Foil & Cutter cassette and the long hair
trimmer.
The shaver should be cleaned after each foam usage.
Cleaning with a brush:
• Switch off the shaver. Remove the Foil & Cutter cassette (8) and tap it out on a flat
surface. Using a brush, clean the inner area of the pivoting head. However, do not
clean the cassette with the brush as this may damage it.
Cleaning the housing
From time to time clean the housing of the shaver and the Clean&Renew station with
a damp cloth, especially inside the cleaning chamber where the shaver rests.
Replacing the cleaning cartridge
After having pressed the lift button (2) to open the housing, wait for a few seconds
before removing the used cartridge to avoid any dripping. Before discarding the used
cartridge, make sure to close the openings using the lid of the new cartridge, since the
used cartridge will contain contaminated cleaning solution.
Keeping your shaver in top shape
Replacing the Foil & Cutter cassette / reset
To maintain 100% shaving performance, replace the Foil & Cutter cassette (8), when
the replace ment symbol (16d) lights up on the shaver display (after about 18 months)
or when cassette is worn. The replacement symbol will remind you during the next 7
shaves to replace the Foil & Cutter cassette. Then the shaver will automatically reset the
display.
After you have replaced the Foil & Cutter cassette, use a ball-pen to push the reset
button (15) for at least 3 seconds to reset the counter. While doing so, the replacement
light blinks and goes off when the reset is complete. The manual reset can be done at
any time.
18