Publicidad
Idiomas disponibles
Idiomas disponibles
Battery
performance
dropped
significantly.
Shaving
performance
dropped
significantly.
Shaver turns
off with fully
charged battery.
Battery
segments in the
display are
skipped with
decreasing
battery capacity.
Shaving parts
have been
changed recently
but replacement
symbol lights up.
Shaver head is
damp.
20
1. Foil and cutter are worn
which requires more power
for each shave.
2. Shaver head is regularly
cleaned with water but not
lubricated.
1. Foil and cutter are worn.
2. Personal setting of shaving
performance has been
changed.
3. Shaving system is clogged.
Foil and cutter are worn
which requires more power
than the motor can deliver.
The appliance turns off.
Foil and cutter are worn
which requires more power
for each shave.
Reset button has not been
pushed.
1. Drying time after automatic
cleaning was too short.
2. Drain of the Clean&Renew
station is clogged.
3. Cleaning cartridge has
been used for quite a while.
1. Renew Foil & Cutter cassette.
2. If the shaver is regularly cleaned
with water, apply a drop of light
machine oil on top of the foil once a
week for lubrication.
1. Renew Foil & Cutter cassette.
2. For a thorough and fast shave we
recommend the green (intensive)
setting.
3. Soak the Foil & Cutter cassette into
hot water with a drop of dish liquid.
Afterwards rinse it properly and tap
it out. Once dry apply a drop of light
machine oil on the foil.
– Renew Foil & Cutter cassette.
– Regularly oil the shaving system,
especially when cleaning with water
only.
– Renew Foil & Cutter cassette.
– Regularly oil the shaving system,
especially when cleaning with water
only.
– Push the reset button for at least 3
seconds to reset the counter.
1. Clean directly after shaving to allow
enough time for drying.
2. Clean the drain with a wooden
toothpick. Regularly wipe the tub
clean.
3. The ethanol/isopropanol proportion
has decreased while the oil
proportion has increased. Remove
residue with a cloth.
Publicidad
