Publicidad
Idiomas disponibles
Idiomas disponibles
1
SWITCHING OFF POWER
Switch off the power to all wires leading to
the assembly location, i.e. the door chime,
electric door opener, power supply unit for
the video door station etc.
3
DETERMINING THE ASSEMBLY LOCATION
The device uses an ultra wide-angle hemispheric
lens so that even when the person is a minimum
distance of 50 cm (19.68 in) away from the device,
a low installation height is sufficient. The lens is
therefore not mechanically adjustable. The camera
lens should be located at an altitude of at least
145 cm (57 in).
You may check this prior to the final mounting.
Only for D1101V & D1102V
We offer additional wall-mounting kits for D1101V and D1102V Surface-Mount with a wedge corner wall-mount
adapter (7.5° vertical down or up) and alternatively an angle corner wall-mount adapter (45° horizontal, mounts
left or right).
When choosing the assembly location, consider the lighting conditions. Avoid direct sunlight, direct backlight
and reflective surfaces.
Do not expose the device to direct sunlight. The housing temperature can exceed the maximum
NOT IC E
allowed temperature limit. This can result in damage of electric and mechanic components of the
device and injuries especially when touching exterior parts of the device. White and bright silver-colored
front plates absorb less sunlight than dark ones.
An image sensor must not be exposed to direct sunlight for an extended period of time. Direct sunlight
NOT IC E
will "blind" the camera and may permanently bleach the small color filters on the image sensor chip.
Any defects caused by direct sunlight are not covered by warranty.
8
A8001 Wedge corner
wall-mount adapter
(7.5°, mounts vertical
down or up), sold
separately
DISMANTLING THE EXISTING
2
DOORBELL
Should there already be a doorbell or door station on
the exterior wall of the house, please remove it.
A8002 Angle corner
wall-mount adapter
(45° horizontal, mounts
left or right), sold
separately
Publicidad
