Descargar Imprimir esta página

Freezer Compartment - GE 21 Manual Del Propietario E Instalación

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 73
Replacing the light bulbs.
Setting the controls to 0 (off) does not remove power to the light circuit.
Your light shield will look like
one of the following:
Tabs
OR
Pocket
Refrigerator Compartment—Upper Light
Unplug the refrigerator.
The bulbs are located at the top of
the compartment, inside the light shield.
On some models, a screw at the front of
the light shield will have to be removed.
On other models, the screw is located in the
pocket located at the back of the light shield.
To remove the light shield, on some models,
press in on the tabs on the sides of the shield
and slide forward and out. On other models,
just slide the shield forward and out.
Refrigerator Compartment—Lower Light
This light is located above the top drawer.
Unplug the refrigerator.
Remove the convertible meat drawer control
knob by pulling straight out.
Lift the light shield up and pull it out.

Freezer Compartment

Unplug the refrigerator.
Remove the shelf just above the light shield.
(The shelf will be easier to remove if it is
emptied first.) On some models, a screw
at the top of the light shield will need to
be removed.
To remove the light shield, press in
on the sides, and lift up and out.
Dispenser
Unplug the refrigerator.
The bulb is located on the dispenser under
the control panel. Remove the light bulb
by turning it counterclockwise.
After replacing the bulb with an appliance
bulb of the same or lower wattage, replace
the light shield and screws (on some models).
When replacing the light shield, make sure
that the tabs at the back of the shield fit
into the slots at the back of the light shield
housing.
Plug the refrigerator back in.
After replacing the bulb with an appliance
bulb of the same or lower wattage, replace
the shield and the knob.
Plug the refrigerator back in.
Replace the bulb with an appliance bulb
of the same or lower wattage, and reinstall
the light shield. When reinstalling the light
shield, make sure the top tabs snap
securely into place. Replace the screw
(on some models).
Reinstall the shelf and plug the refrigerator
back in.
Replace the bulb with a bulb of the same
size and wattage.
Plug the refrigerator back in.
19

Hide quick links:

Publicidad

loading

Este manual también es adecuado para:

23252729