Publicidad
Idiomas disponibles
Idiomas disponibles
A first-time user is advised at the least to practice cutting
logs on a sawhorse or frame.
When sawing on a slope, always stand above the tree
trunk. To maintain full control at the moment of „sawing
through", nearing the end of the cut reduce the contact
pressure without loosening your grip on the chain-saw
handles. Make sure that the saw-chain does not touch
the ground. After finishing the cut, wait for the saw-
chain to stop moving before extracting the chainsaw
from the cut. Always switch off the chain saw motor
before moving to the next tree.
Spiked Bumper
When sawing, press the chain saw forward so that the
„claw" bites into the bark. Lifting the rear handle up or
down in the direction of the cut reduces the physical
strain during sawing. When making a cut, the claw stop
can also be used as a pivot point and is very useful in
keeping the body of the chainsaw stable during cutting.
Chain Brake
To reduce the risk of injury, the chain must stop immedi-
ately once the chain brake lever is pressed towards the
hand, as shown in the images. This can not, however,
prevent a rebound. The proper function of the chain
brake must be checked each time before the chain saw
is used.
Chain Catcher
This prevents the chain from being flung towards the
user if it comes loose or breaks.
Battery
Risk of fire! Risk of explosion!
Never use damaged, defective or deformed accumu-
lators. Never open or damage the accumulator or let
it fall on the ground.
Never charge the battery in an environment with
acids and easily flammable materials.
Protect the battery against heat and fire.
Battery to be used at the ambient temperatures
between 10°C and +40°C only.
Never put the battery on heaters and do not expose
it to strong sunlight for a long time.
After being subject to heavy load, let the battery
cool down first.
Short circuit - do not bridge the accumulator con-
tacts with metal parts.
The accumulator must be packaged (plastic bag,
box) or accumulator contacts must be sealed up for
accumulator disposal, transport or storage.
The Güde charger to be used only to charge the battery.
There can be malfunction or fire if different chargers are
used.
Vapours may leak out in case of unauthorised use or
when using a damaged accumulator. Bring fresh air and
seek medical advice if experiencing difficulties. Vapours
may irritate the respiratory system.
Working Instructions
Accumulators are supplied partially charged and must
therefore be fully charged before being used for the first
time.
• Charge the accumulator when the appliance is running
slowly or stops.
• A li-ion battery may be charged at any time without
any shortening of its life. Charging process interrupti-
on will not damage the accumulator.
• A li-ion battery is protected by the Electronic Cell
Protection against deep discharge.
• A significantly shorter operating time of a charged
battery means the battery life is over and the battery
must be replaced.
Dispose of the batteries in an environ-
mentally friendly manner.
Li-ion batteries are subject to the special
disposal obligation. Have any defective
Li-Ion
batteries disposed of by a specialised shop.
The battery must be taken out before the
appliance is scrapped. Damaged batteries
may harm the environment and your health
if toxic vapours or liquids leak out of such
batteries.
Therefore, never send a defective battery by
post, etc. Please contact your local recycling
centre.
Dispose of the batteries when discharged.
We recommend applying an adhesive tape
on the poles to protect them against short
circuit. Never open the battery.
Maintenance
Take the replaceable battery from the
appliance before any extension, cleaning
and servicing works.
Carry out a visual inspection before switching the
appliance on.
The appliance must not be used if damaged or safety
equipment is defective. Replace any worn-out and
damaged parts.
If the device is defective, the repair has to be made
exclusively by the customer service. Use only original
accessories and original spare parts. Components for
which there are no instructions for exchanging should
be replaced by the manufacturer only.
Only a regularly maintained and treated appliance can
serve as a satisfactory aid. Insufficient maintenance and
care can lead to unforeseen accidents and injuries.
ENGLISH
31
Publicidad
