Gude KS 36-0 Traducción Del Manual Original página 37

Inspection and maintenance plan
Generally
Before any start-up
After every take out of
service
Storage
Defects searching
Failures
The saw does not work
Not sufficient output
Missing chain lubrication
Chain Brake
Follow-up brake
Complete saw
Plastic body
Saw Chain
Chain saw bar
Chain saw wheel
Chain Brake
Saw Chain
Chain saw bar
Chain lubrication
Chain Brake
Follow-up brake
On/off Button
Oil tank cap
Chain saw bar
Bar fixture
Chain oil tank
Saw Chain / Chain saw bar
Complete saw
Tracing
Electric motor does not run
or stops.
Low dilatability
Chain is not lubricated
Chain does not stop quickly
Saw chain runs out
Regularly clean the outer part
Let regularly checked by authorized workshop
Check for cracks and fissures
Let regularly sharpen
Clean regularly
Clean regularly
Regular functional test
Check for damages and sharpness
Check the chain tension
Functional test
Functional test
Functional test
Functional test
Check for tightness
Let regularly checked by authorized workshop
Clean the oil top-up opening
Clean above all guiding oil groove
Drain
Dismount, clean and lubricate slightly by oil Clean the
saw guiding groove
Store safely in dry room Have the battery chain saw
checked by an authorized workshop after long term
storage (remaining oil can be resinous and clog the oil
pump valve)
Causes
Voltage missing
Battery is defective
Battery compartment
defective
Chain brake activated
Activated power breaker
Worn-down carbon brushes
Empty oil tank, Dirty gui-
ding oil groove
Braking system worn.
Worn-down carbon brushes
ENGLISH
Removal
Reinsert battery
Insert new battery
Akkuschacht durch Fach-
werkstatt oder Güde-Service
erneuern lassen
Release chain brake (see
chapter „Operation" )
Check supply line, consult
specialist workshop.
Have the carbon brushes
replaced by a specialist
workshop.
Fill up the oil tank. Clean
the oil guide groove on the
chain blade.
Consult a specialist work-
shop immediately.
Have the carbon brushes
replaced by a specialist
workshop.
33