Installing The Air Filter - Kenmore 596.7238 Manual De Uso

Ocultar thumbs Ver también para 596.7238:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

The Water
Filter Status Light
Press SETTINGS on the control panel to launch the Settings
menu. Press SETTINGS, under Filter Status, again to display the
percentage
of filter life remaining (from 99% to 0%). Press ICE/
WATER, under Back, to return to the Normal screen.
The water filter status lights will help you know when to change
your water filter.
ORDER FILTER (yellow) - it is almost time to change the
water filter. While you are dispensing water, "Order
Filter"
will blink seven times and sound an alert tone three times.
REPLACE FILTER (red) - Replace the water filter. While you
are dispensing water, "Replace Filter" will blink seven times
and an alert tone will sound three times.
RESET the water filter status tracking feature. After you
replace the disposable filter with a new filter, closing the
filter compartment
door will automatically
reset the filter
status tracking feature. See "Using the Control(s)."
NOTE: "REPLACE FILTER" will remain illuminated
if a filter is
not installed or is installed incorrectly.
Replace the Water
Filter
To purchase a replacement
water filter, see "Accessories"
in the
User Guide, Use and Care Guide or User Instructions.
Replace the disposable water filter when indicated
on the water
filter status display or at least every 6 months. If water flow to
your dispenser or ice maker decreases noticeably,
change the
water filter sooner.
1. Locate the water filter compartment
in the right-hand
side
of the refrigerator
ceiling. Push up to release and lower the
compartment
door.
2. Turn the water filter counterclockwise
(to the left), and pull it
straight out of the compartment.
NOTE: There may be some water in the filter. Some spilling
may occur. Use a towel to wipe up any spills.
.
Install the replacement
water filter by following
steps 2
through 7 in the "Install the Water
Filter" section.
s<s
Ab s:e
An air filter is 15 times more powerful than baking soda at
reducing common food odors inside the refrigerator.
On some models, your refrigerator's
accessory packet includes
an air filter, which must be installed prior to use.
Installing the Air Filter
Install the air filter behind the vented door, located on the rear
wall near the top of the refrigerator
compartment.
1. Remove the air filter from its packaging.
2. Lift open the vented door.
3. Snap the filter into place.
A. Air
filter
Installing the Filter Status Indicator
The filter comes with a status indicator, which should be
activated
and installed at the same time the air filter is installed.
1. Place the indicator face-down
on a firm, flat surface.
2. Apply pressure to the bubble on the back of the indicator
until the bubble pops to activate
the indicator.
17

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

W10675342a

Tabla de contenido