Viewing And Adjusting Temperature Set Points - Kenmore 596.7238 Manual De Uso

IMPORTANT." The display screen on the dispenser control panel
will turn off automatically and enter "sleep" mode when the
control buttons and dispenser paddles have not been used for
2 minutes or more. Press any control button to reactivate the
display screen. The home screen will appear as shown.
View Temperature Set Points
1. Press and hold TEMP for 3 seconds to activate Temperature
mode.
NOTE. To view temperature in degrees Celsius, press the
ACCENT LIGHT button, under Units, when adjust mode is
activated. To return the display setting to Fahrenheit, press
the ACCENT LIGHT button again.
When Temperature mode is activated, press TEMP to toggle
between Fridge and Freezer. The display will show the
temperature set point of the selected compartment, and
temperature adjusting information will appear on the
display screen.
Recommended Refrigerator Temperature
Viewing and Adjusting Temperature Set Points
For your convenience, your refrigerator and freezer controls are
preset at the factory.
When you first install your refrigerator, make sure that the
controls are still set to the recommended set points. The factory
recommended set points are 37°F (3°C) for the refrigerator and
0°F (-18°C) for the freezer.
IMPORTANT:
• Wait 24 hours before you put food into the refrigerator. If
you add food before the refrigerator has cooled completely,
your food may spoil.
NOTE" Adjusting the set points to a colder than
recommended setting will not cool the compartments any
faster.
If the temperature is too warm or too cold in the refrigerator
or freezer, first check the air vents to be sure they are not
blocked before adjusting the controls.
The recommended settings should be correct for normal
household use. The controls are set correctly when milk or
juice is as cold as you like and when ice cream is firm.
NOTE. Areas such as a garage, basement or porch, may
have higher humidity or extreme temperatures. You may
need to adjust the temperature away from the
recommended settings to accommodate for these
conditions.
• Wait at least 24 hours between adjustments. Recheck the
temperatures before other adjustments are made.
Recommended Freezer Temperature
Adjust Temperature Set Points
Refrigerator set point range: 33°F to 45°F (0°C to 7°C).
Freezer set point range: -5°F to 5°F (-21°C to -15°C).
1. When Temperature mode is activated, press TEMPERATURE
to select the Refrigerator zone. The display will show the
temperature set point of the selected compartment, as
shown.
2.
3.
Press LOCI( to raise the set point, or press SETTINGS to
lower the set point.
When you have finished viewing (and adjusting if desired)
the refrigerator set point, press TEMP, under Select Zone, to
change the display to show the freezer set point. When the
zone has been changed, "FREEZER" appears on the display
screen.
4. Press the LOCI( button to raise the set point, or press the
SETTINGS button to lower the set point.
19