Publicidad
Idiomas disponibles
Idiomas disponibles
English
Door Alignment
Freezer Door:
1. Remove hinge cover screw.
2. Remove the top hinge cover.
3. Loosen the top hinge screws using a Phillips head screwdriver.
4. Adjust the door or put a spacer in between and then tighten the screws.
5. Replace the top hinge cover.
Hinge
cover
Reversing the Door Swing
Left/right door opening method:
This product allows you to reverse the door opening from left to right and
back. You can select your preference of door opening by following the
procedure to make the change.
Dismantling:
1. Affix refrigerator and freezer door by sticking adhesive tape on both
sides to hold doors in place.
2. As shown in fig. 1, dismantle the hinge cover on the upper part of
freezer door with a Phillips head screwdriver. Then remove the three
screws that hold the hinge. Take out the hinge by pulling it vertically,
and keep it in a safe place.
3. Remove the adhesive tape on freezer door, lift it and take off the door,
and carefully put it aside.
4. Dismantle two screws of the central hinge, lift it and take off the central
hinge, and keep them in a safe place. (see fig # 2)
5. Remove the adhesive tape on refrigerator door, lift it and take
refrigerator door, and carefully put it aside.
6. Remove the doorstoppers from the refrigerator and freezer doors.
7. Insert left side doorstopper (provided in your packing) on the left side
bottom hole of the refrigerator door and on the left side bottom hole of
7
the freezer door. Fasten with screws provided.
(see fig. # 1)
Top hinge
(see fig. # 1 and fig. # 2)
fig. # 1
Publicidad
