Echo CS-620SX Manual Del Operador página 10

1. Spiked bumpers - Device, fitted in front of the guide bar
mounting point, acting as a pivot when in contact with a
tree or log.
2. Silencer - The silencer controls the exhaust noise and
prevents hot, glowing particles of carbon from leaving the
silencer.
3. Front hand guard - Guard between the front handle and
the saw chain for protecting the hand from injuries and
aiding in control of the chain saw if the hand slips off the
handle.
This guard is used to activate the chain brake which is to
stop the saw chain rotation.
4. Choke control knob - Device for enriching the fuel / air
mixture in the carburettor to aid cold starting.
5. Rear handle (for the right hand) - Support handle
located towards the rear of the engine housing.
6. Rear hand guard - Extension on the lower part of the
rear handle for protecting the hand from the chain if it
breaks or degrooves.
7. Clutch cover - Protective cover to the guide bar, saw
chain, clutch and sprocket when the chain saw is in use.
8. Chain tension adjuster - Device to adjust chain tension.
9. Chain catcher - A projection designed to reduce the risk
of the operator's right hand from being hit by a chain
which has broken or derailed from the guide bar during
cutting.
10. Guide bar - The part that supports and guides the saw
chain.
11. Chain - Chain, serving as a cutting tool.
Description
12. Oil tank cap - For closing the oil tank.
13. Starter handle - The grip of the starter, for starting the
engine.
14. Fuel tank cap - For closing the fuel tank.
15. Ignition switch - Device for connecting and
disconnecting the ignition system and thus allowing the
engine to be started or stopped.
16. Throttle trigger - Device activated by the operator's
finger, for controlling the engine speed.
17. Throttle trigger lockout - A safety lever which must be
depressed before the throttle trigger can be activated in
order to prevent the accidental operation of the throttle
trigger.
18. Air cleaner cover - Covers air filter.
19. Cleaner cover knob - Device for installing the air
cleaner cover.
20. Decompression device - Device for lowering the
compression in the cylinder, to aid starting.
21. Safety decal - Part number 890345-39231
22. Front handle (for the left hand) - Support handle
located at the front of the engine housing.
23. Cylinder cover - The cooling air flow grill.
It cover the cylinder, spark plug and silencer.
24. Operator's manual - Included with unit.
Read before operation and keep for future reference to
learn proper, safe operating techniques.
25. Tools - 13 x 19 mm T-wrench (combination screwdriver
/ spark plug socket), L-wrench and small screwdriver.
26. Guide bar cover - Device for covering the guide bar and
saw chain during transport and other times when the
chain saw is not in use.
10