Batavia Maxxspray BT-PSS001 Manual De Usuario página 14

English
b. How to spray properly
(See Fig. E, F).
• Hold the spray gun at a constant dis-
tance from the object. The ideal spraying
distance is approx. 15 cm.
• Spray evenly up and down with smooth
passes at a consistent speed as illus-
trated in fig. E. Doing this will help avoid
irregularities in the finish (i. e. runs and
sags).
• Always apply a thin coat of material on
the first pass and allow to dry before
applying a second, slightly heavier coat.
• The closer your sprayer is to the object
being sprayed the more the over-spray.
• When spraying, always press and hold
the trigger of the spray gun after spray
pass has begun and release trigger
before stopping the pass. Always keep
the gun pointed squarely at the spray
surface and overlap passes slightly to
obtain the most consistent and profes-
sional finish possible.
9. Cleaning the spray gun
(See Fig. G).
Special clean-up instructions for
use with flammable solvents (must
have a flash point above 21 °C):
• Always flush spray gun outside.
• Area must be free of flammable vapours.
• Cleaning area must be well-ventilated.
• DO NOT SUBMERGE air compressor!
Unplug the spray gun, and trigger the
9.1
spray gun so that the material inside the
spray gun flows back into the container.
Unscrew the container (11). Empty any
9.2
remaining material back into the mate-
rial container.
Pour a small amount of the appropriate
9.3
cleaning solution into the container
(warm, soapy water for latex materials;
mineral spirits for oil-based materials).
Clean container and properly dispose of
cleaning solution.
Refill the container with NEW cleaning
9.4
solution.
Attach the container to the gun and
9.5
plug in the sprayer.
12
Spray the solution through the gun for
9.6
two seconds in a safe area. Spray again
for two seconds. Unplug the spray gun,
and trigger the spray gun so that the
material inside the spray gun flows
back into the container.
Wipe the exterior of the container and
9.7
gun until clean.
Unscrew the nut (1) and remove the air
9.8
cap (2) and nozzle (3).
Clean the container, suction tube, air
9.9
cap and nozzle with a cleaning brush
and the appropriate cleaning solution.
Never clean nozzle or air holes in the spray
gun with sharp metal objects.
Do not use solvents or lubricants contain-
ing silicone.
Twist and separate the spray gun from
9.10
the handle. Clean the rear of the spray
gun (16) with the appropriate cleaning
solution. Use a thin layer of petroleum
jelly to lubricate the O-ring.
Dry all parts thoroughly.
9.11
Place a drop of household oil into the
9.12
inside of the sprayer from the hole for
assembling the spray tip.
Reassemble spray gun
9.13
Note: Spray nozzle can only be assembled
in one direction that the notch of the nozzle
must align with the skirt on spray unit
housing.
Note: The spray tip must be assembled in
the sprayer with the bumps on the spray tip
in vertical direction.
Note: Assemble the pickup tube and check
valve by firmly pushing them onto the inlet
in the spray.
Wrap the air hose around the power unit
9.14
and put all accessories back into place.
10. Maintenance
(See Fig. H).
You should inspect the air filter in the Air
Compressor Assembly to see if it is exces-
sively dirty. If it is dirty, follow the steps
below to replace it.
a. Unplug the spray gun. Remove the filter
cover with your hands directly.
b. Remove the dirty filters and replace with
new ones.