Checking/Replacing Battery(Ies) Of Remote Control - Num'axes CANICOM 800 Manual De Instrucciones

Ocultar thumbs Ver también para CANICOM 800:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 35
Configuration of the "Booster" button:
Programming the Booster button for the dog A or 1 (black collar):
- press « A » or « 1 » button for 5 seconds (level of stimulations flashes on the LCD screen)
- press the « + » or « - » button to modify the level of stimulations
- press the « A » or « 1 » button to confirm the level
Renew the same procedure to program the Booster button for the dog B or the dogs 2, 3 and 4.
O « + » and « - » : control buttons
Use the +/- buttons for rapid adjustment of the stimulation level of the receiver collar.
15 levels are available for CANICOM 800.
18 levels are available for CANICOM 1500.
Level 1: very weak stimulations. Level 15 or 18: strong stimulations.
Always start with the lowest level of stimulation.
O Retro-lightning of the LCD screen
You can light the LCD screen for approximately 6 seconds by pressing briefly the On/Off switch
(approx. 1/2 second).

Checking/replacing battery(ies) of remote control

Performance (radio range) of the remote control may deteriorate as battery(ies) become(s) weak.
Be prepared to replace the battery(ies).
To check the condition of the battery(ies), turn on the remote control CANICOM 800/CANICOM 1500 and
look at the battery level indicator on the LCD screen. The symbols which appear indicate the following:
Remove the old battery(ies) and replace it (them):
- 1 3-V Lithium CR2 battery for the CANICOM 800 remote control
- 2 LR06 alkaline batteries for the CANICOM 1500 remote control
Replace the battery(ies) as follows:
- On the back of the remote control, unscrew the screw and remove the battery cover (ref.
Diagram 9 or 10).
- Remove the old battery(ies).
- Insert the new battery(ies) paying attention to follow polarity indicated on the battery
housing. For CANICOM 800, a tab is under the battery.
Battery fully charged.
Weak battery: prepare to replace the battery.
Dead battery: your CANICOM 800/CANICOM 1500 functions in safety mode and
the system locks up. The battery(ies) must be replaced.
Gb - 27
( (

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Canicom 1500Canicom 800

Tabla de contenido