- Put the battery cover back in place, (for CANICOM 800, make sure the tab is in correct position
inside the battery housing to maintain water tightness).
- Retighten the screw.
- Check the remote control operates correctly.
Replacing battery
of CANICOM 800
remote control
Diagram 9
Checking/replacing battery of receiver collar(s)
To check the condition of the receiver collar battery, observe the On/Off indicator located on the front of
the receiver collar:
- Battery fully charged: flashes slow green.
- Weak battery: flashes quickly red. Replace it with a new lithium 3 Volts CR2 battery (See § First
use from new: fitting the battery in the receiver collar).
Check the receiver collar operates correctly.
Changing the contact points
Two different series of contact points are supplied. The length of the contact points must be sufficient to
have proper contact with the dog's skin, enabling the device to operate correctly.
If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate,
remove and replace them with the long ones supplied with the kit. Carefully tighten them manually (do
not use a key).
How to check that your CANICOM 800/CANICOM 1500 is functioning properly
You can check that your CANICOM 800/CANICOM 1500 is operating correctly at any time.
- Before doing so, make sure that the receiver collar is turned « off ».
- Place the test lamp in contact with each of the contact points (by unscrewing them then by
Gb - 28
WARNING
Make sure the polarity is correct
Replacing batteries
of CANICOM 1500
remote control
Diagram 10