Publicidad
Idiomas disponibles
Idiomas disponibles
Attach the Table Legs (5) to the Extension Table (6) as shown
in Figure 6.
1.
Lay the Extension Table (6) upside
down on the floor or on a bench.
2.
Position the Table Leg (5) in the corner of the
Extension Table (6) as shown in Figure 6.
3.
Attach the Table Leg to the Table Board with four #8
x 3/4" Wood Screws (n). Drill a 1/4" hole through
the two holes in the Bracket (A) and through the
Table Skirt. Secure the Table Leg to the Table Skirt
using 10-32 x 1-3/4" Pan Head Bolts (m), 7/32 x
1/2" Flat Washer (h), and #10-32" Hex Nut (k).
Next, attach the Threaded Leveling Feet to each leg as shown
in Figure 7.
1.
Assemble the 3/8-16" Hex Nut (j) onto Leveling Feet (q).
2.
Thread the Leveling Feet into bottom of Table Leg (5).
3.
Repeat Steps 1 & 2 for the other Foot Assembly.
NOTE: Height adjustment will be made later.
4.
Place Table Assembly (6) in position between the two
rails as shown in Figure 8. Make sure the Saw Table
Edge (B) is flush against edge of the Extension Table.
5.
Using a Straight Edge (C), make sure the Extension
Table is in the same plane and level with Saw Table. If
necessary, lightly tap up or down and adjust Leveling
Feet to bring Extension Table level with Saw Table.
6.
Use Bar Clamps to secure the Extension Table to the
Front and Rear Guide Rails as shown in Figure 9.
7.
Using the Holes in the Front and Rear Guide Rails,
shown in Figure 9, as a template, drill 1/4" holes
through the front and rear of the Extension Table.
8.
Secure the Extension Table to the Front Guide
Rail using 1/4-20 x 1-1/2" Countersunk Screws
(p), 5/16 x 5/8" Flat Washers (l), and 1/4-20" Hex
Nuts (i). Secure the Extension Table to the Rear
Guide Rail using 1/4-20 x 1-1/2" Hex Head Screw
(o) with the same Flat Washers (l) and Hex Nuts
(i) that were used for the Front Guide Rail.
FIGURE 9
ASSEMBLY
6
n
8
5
FIGURE 6
q
j
FIGURE 7
b
c
FIGURE 8
A
5
6
Publicidad
