Mountfield Azuro 2m3/h Manual De Instalación página 11

Controlling the Multi-port Valve
Always disconnect the appliance from the power supply
prior to valve position changes.
Prior to the handling, wait for about half a minute after the
pump has been turned off to let the impurities and sand set
down.
Push the lever downwards (FIG. 12.1), turn it to the required position (FIG. 12.2).
Care
Visible impurities are removed using the filtering system. However, that is not the case for algae, bacteria and
micro-organisms, which are a constant obstacle when striving for clean, safe water in your pool. There are many
specialized preventive products, which in correct concentrations work against all of the above and keep the water
in your pool hygienically sound and clean.
Maintenance
During the swimming season, regularly check the operation of the appliance. It is important for identification and
remedy of potential defects. The supplier cannot be held liable for damage cause by filtering unit or electrical
equipment defects.
Rinse the sand on regular basis. If the rinsing does not improve the permeability of the filtering sand (i.e. the
pressure gauge value remains high), change the sand.
Do not use solvents to clean the filter cap or the vessel itself, as you could damage its surface (it could lose its
gloss, transparency etc.).
Winterizing
At the end of the season, it is necessary to clean, drain, disassemble and store the filtering equipment. Disconnect
the filtering equipment from the pool and use the draining valve, which is located at the bottom of the filtering
vessel, to drain the water from the vessel.
Open the filter vessel and take the sand out. Clean the sand and remove any lumps or gobs. Change the sand in
the vessel on regular basis.
As preparation for winter, re-assemble the filtering equipment and store it in a winter-resistant and dry room.
Turn the valve lever to the VENTING/WINTERIZING position, which is used to winterize the filtering equipment.
Warranty Terms and Servicing
Warranty conditions apply as described in the seller's warranty certificate.
In case you need an advice, service support or a spare part, contact your dealer. Use original spare parts for
maintenance and repair purposes.
Product Tests
The product is a subject to EN 60335-2-41 and in conformity with the directives 2006/42/ES (the machinery
directive), 2014/30/EU (electromagnetic compatibility), 2014/35/EU (electrical devices) and the requirements of
the RoHS directive on hazardous substance content in electrical devices. The product has been tested in the
Government Testing
Laboratory of Machines