Publicidad
Idiomas disponibles
Idiomas disponibles
STORAGE
CAUTION: Never place any type of storage cover or tarp on the MOWER while it is still hot.
If the MOWER is being stored for extended periods of time (30 days or more), drain fuel tank and carburetor
bowl.
When storing the mower for extended periods of time:
1. Start the engine and run it until the tank, carburetor bowl and fuel line are completely empty and the engine
stalls.
2. Change the oil after each season.
3. Remove the spark plug. Use an oil-can to fill the cylinder with approx. 2 ml of oil. Slowly pull back the starter
handle, which will bathe the cylinder wall with oil. Screw the spark plug back in.
4. Clean the cooling fins of the cylinder and the housing.
5. Be sure to clean the entire equipment to protect the paint.
6. Store the equipment in a well-ventilated place.
NOTE: LIMITED WARRANTY does not cover fuel system damage or engine performance problems
resulting from neglected storage preparation.
TROUBLESHOOTING
Problem
Engine fails to start
Engine runs erratic.
Engine overheats.
Idles poorly.
Excessive vibration/noise
Mower will not mulch
grass.
Uneven cut.
Cause
Engine start/stop lever disengaged. Engage engine start/stop lever.
Spark plug wire disconnected.
Fuel tank empty or stale fuel.
Engine not primed.
Faulty spark plug.
Blocked fuel line.
Engine flooded.
Spark plug wire loose.
Blocked fuel line or stale fuel.
Water or dirt in fuel system.
Dirty air filter
Engine oil level low.
Air flow restricted.
Spark plug fouled, faulty, or gap
too wide.
Dirty air cleaner.
Blade loose or unbalanced.
Bent/damaged blade.
Wet grass.
Excessively high grass.
Dull blade.
Solution
Connect spark plug wire.
Fill tank with clean, fresh gasoline.
Press primer bulb.
Clean, adjust gap, or replace.
Clean fuel line.
Wait a few minutes to restart, do not prime.
Connect and tighten spark plug wire.
Clean fuel line. Fill tank with clean, fresh
gasoline. Drain carburetor bowl.
Drain fuel tank. Refill with fresh fuel.
Clean or replace the filter.
Fill crankcase with proper oil.
Clean area around and on top of engine.
Reset gap or replace spark plug.
Clean or replace the filter.
Tighten and balance blade.
Replace the blade.
Do not mow when grass is wet, wait until dry
to cut.
Mow once at a high cutting height, then mow
again at desired height or make a narrower
cutting path.
Sharpen or replace blade.
18
Publicidad
