Silverline 868544 Traducción Del Manual Original página 11

Maintenance
WARNING: Always disconnect the machine from the air supply before carrying out any
maintenance or cleaning.
Note: Two Hex Keys (9) are provided with this air nailer that are suitable for partial disassembly of
this unit. These may be useful for cleaning, unjamming and replacing parts. Such disassembly is not
covered by this manual.
WARNING: Never use third party spares with this product. Only use spares supplied by Silverline
or an authorised Silverline stockist or repair centre.
General inspection
• Regularly check that all the fixing screws are tight. They may vibrate loose over time.
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the machine's service life. Clean the body of your machine with a soft brush, or dry cloth.
IMPORTANT: There is very little that can go wrong with your air tool and it should be noted that
when an air tool fails to work it is generally because the internal workings have corroded due to
dirty, wet air and failure to follow the instructions given below.
Daily maintenance procedure
If an inline lubricator is not fitted to the air supply, the tool must be manually lubricated:
1. Disconnect from the air supply and remove any fasteners.
2. Pour 3-4 drops of oil into the air intake.
3. Reconnect the air supply and operate the machine several times to lubricate all internal
workings.
• If the machine is in constant use or used for long periods at a time, repeat the above procedure
up to 3 times per day.
• Use air tool oil. DO NOT UNDER ANY CIRCUMSTANCES USE NORMAL ENGINE OIL.
• Failure to comply with the operating and maintenance instructions may invalidate the guarantee.
Storage
• Store this tool carefully in a secure, dry place out of the reach of children.
Contact
For technical or repair service advice, please contact the helpline on (+44) 1935 382 222
Web: www.silverlinetools.com
UK Address:
Toolstream Ltd.
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
EU Address:
Toolstream B.V.
Hogeweg 39
5301 LJ Zaltbommel
The Netherlands
Disposal
• As with other power tools, air tools should not be disposed of with household waste.
• Air tools may contain traces of tool oil and other lubricants and so must be recycled accordingly.
• Contact your local waste disposal authority for information on the correct way to dispose of
air tools.
Air Brad Nailer 50mm
silverlinetools.com
11