Roborock S7 MaxV Plus Manual Del Usuario página 13

Washable Filter
C6
* Clean every 2 weeks and replace every 6-12 months.
C6-1— Open the filter cover and remove the
filter.
C6-2— Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
Note: Do not touch the surface of the filter with your hands,
brush, or hard objects to avoid potential damage.
C6-3— Allow 24 hours for the filter to dry
thoroughly and reinstall it.
Note: Purchase an additional filter and alternate if necessary.
Water Tank
C7
* Clean as required.
C7-1— Open the water tank and fill it with
clean water.
C7-2— Close the water tank and shake it
gently.
C7-3— Pour out the remaining water as
shown.
VibraRise Mop Cloth
C8
* Clean after each use and replace every 3-6 months.
C8-1— Remove the VibraRise mop cloth from
the VibraRise mop bracket. Clean the
VibraRise mop cloth and air-dry it.
Note: A dirty VibraRise mop will affect the mopping
performance. Clean it before use.
Robot Sensors
C9
* Clean monthly.
Use a soft, dry cloth to wipe and clean all
sensors, including:
C9-1— ReactiveAI Obstacle Recognition
C9-2— Wall Sensor
C9-3— Mop Wash Sensor
C9-4— Carpet Sensor
C9-5— Cliff Sensors
Charging Contact Areas
C10
* Clean monthly.
Use a soft dry cloth to wipe the charging
contacts on the robot.
Battery
The robot is equipped with a built-in
high-performance lithium-ion rechargeable
battery pack. To maintain battery
performance, keep the robot charged
during normal use.
Note: If the robot will be left unused for a long period, turn it
off and charge it at least every three months to avoid battery
damage caused by over-discharge.
Dust Bag Replacement
C11
*Clean as required.
Notes:
• Replace the dust bag regularly or when it is full.
• The disposable dust bag uses a one-time seal design to
effectively prevent dust from spreading outward during
replacement. If you do not want to discard the dust bag,
do not pull out the seal. If the seal is pulled out, it cannot
be restored to the original state, which will affect the use
of the dust bag.
12
C11-1— Open the top lid of the dustbin.
C11-2— Remove the dust bag by its handle
vertically as shown and discard the
dust bag.
Note: The dust bag handle seals the bag on removal to
prevent dust leakage.
C11-3— Replace the dust bag with a new
one. Make sure it is properly
installed.
C11-4— Close the top lid of the dustbin and
make sure it is securely sealed.
Filter Cleaning
C12
* Clean as required.
Notes:
• Do not wash the filter in a dishwasher or washing machine,
or dry using a cylinder dryer, oven, microwave, hot air or
fire.
• Do not touch the surface of the filter with your hands,
brush, or hard objects to avoid potential damage.
• Rinse the filter element with clean water. Do not remove it
from the front filter.
C12-1— Rotate the filter cover counter-
clockwise to remove it.
C12-2— Remove the front filter and/or the
rear HEPA filter as needed.
C12-3— Rinse with cold water until clean.
C12-4— Shake off any remaining water and
leave the filter to dry for 24 hours
or until completely dry.
C12-5— Reinstall the dry filter and close the
cover.