Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
7. Pick up both doors (H) and fasten the hinge bases onto
the side panels with the M4 x 15 mm screws (MM). DO
NOT fully tighten the screws. Close the doors to double
check the alignment. If you find that the doors need to
be adjusted slightly, please refer to the supplement on
page #3 and turn the appropriate screws for a perfectly
aligned door. After adjusted, tighten the screws on the
hinge base to lock the
hinges in place.
Hardware Used
MM
M4 x 15 mm Screw
If you plan to use this unit as hutch (stand this on another
one), please skip step 8.
8. Insert floor levelers (GG) into the bottom of bottom
panel (F).
Hardware Used
GG
Floor Leveler
9. Insert the caps (HH) into the holes on top of the top
panel (A).
Hardware Used
HH
Cap
7
H
H
x 16
8
x 4
GG
9
x 4
HH
9
ASSEMBLY INSTRUCTIONS
10a. Set the shelf pins (NN) at your desired height at the
MM
same level. Tilt and install adjustable shelves (E) in
place.
10b. Plug the plastic covers (II) onto the visible cams
locks to conceal the cams.
Hardware Used
II
Plastic cover
NN
Shelf pin
11. This cabinet was designed with a feature that
allows stacking two units. Additional units sold
separately. Insert wood dowels (CC) into the holes
on top of the base unit. Place bottom of second unit
onto the inserted dowels. Secure units together by
attaching the metal plates (EE) at both ends with the
M3.5 x 19 mm screws (QQ) into the pre-drilled holes.
NOTE: Remove caps (HH) before stacking two units
F
together.
Hardware Used
CC
Wood dowel
EE
Metal plate
QQ
M3.5 x 19 mm Screw
A
10
II
E
x 4
E
x 8
11
CC
x 4
x 1
x 4
10
NN
QQ
EE
Publicidad
