Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
12a. Adjust floor levelers to level the unit against the wall
where desired.
12b. Using back stretcher (B) as a template, mark three
holes to indicate where holes will be drilled.
12c. Drill three pilot holes into the wall where previously
marked.
12d. Make sure that the drilled holes fit the wall anchors
properly.
12e. Press the anchors into the holes and gently tap with
a hammer until flush in the holes. PLEASE NOTE: If the
mounting hole coincides with a wooden stud, there is no
need for a wall anchor.
12f. Align back stretcher (B) and back crossers (RR) over
the drywall anchors (SS) and secure with M5 x 65 mm
screw (TT).
12g. Tighten screws securely with Phillips screwdriver.
If you want this unit flush against the wall, you can cut away the baseboard of the wall, and then
secure with M5 x 65 mm screw (TT) without back crosser (RR).
Hardware Used
Back Crosser
RR
M5 x 65 mm
TT
Screw
CARE AND MAINTENANCE
•
Periodically check to make certain all components are properly positioned, free from damage
and firmly connected.
•
Use a soft, clean cloth that will not scratch the surface when dusting.
•
Never use water to clean the furniture as it may cause damage to the finish.
•
Wipe clean using a damp cloth and a mild cleaner. Wipe dry with a clean cloth.
•
In the event that the furniture is stained or otherwise damaged during use, it is recommended
you call a professional to repair the furniture.
•
Keep furniture away from direct sunlight as it may damage the finish.
•
It is best to keep the furniture in a climate-controlled environment. Extreme temperature and
humidity changes can cause fading, warping, shrinking and splitting of wood.
LIMITED LIFETIME WARRANTY
This product is warranted to the original purchaser. If there is a failure in this unit due to defects in
materials or workmanship, the manufacturer will repair or replace this item at our discretion without
charge. Warranty is void if product has been assembled incorrectly, misused, abused by
overloading, altered in any way or damaged due to accident. This warranty is not transferable and
does not cover chipping, flaking, scratches, rust, dents, or other damages to the surfaces of this
product. Responsibility of the manufacturer is limited to repair or replacement of this product. The
manufacturer is not responsible for consequential, incidental, or other damages or losses resulting
from product failure.
This warranty is in lieu of all other expressed warranties. Some states do not allow the exclusion
or limitation of incidental or consequential damages, so the above limitation may not apply to you.
This warranty gives you specific legal rights and you may have other rights which vary from state
to state.
12
SS
RR
B
TT
x 3
Drywall Anchor
SS
x 3
11
REPLACEMENT PARTS LIST
For replacement parts, call our customer service department at 877-888-8225, 8 a.m. - 8 p.m., EST,
Monday - Sunday or ascs@lowes.com.
PART
DESCRIPTION
Wall
A
Top panel
B
Stretcher
C
Side panel left
D
Side panel right
E
Adjustable shelf
F
Bottom panel
G
Back panel
H
Door
AA
Cam lock
BB
Cam bolt
CC
Wood dowel
DD
M4 x 50 mm Screw
EE
Metal plate
FF
M3.5 x 15 mm Screw
x 3
GG
Floor Leveler
HH
Cap
II
Plastic cover
JJ
5/32 in. x 25 mm Bolt
KK
Handle
LL
Door hinge
MM
M4 x 15 mm Screw
NN
Shelf pin
OO
Door stopper
PP
M3.5 x 13 mm Screw
QQ
M3.5 x 19 mm Screw
RR
Back Crosser
SS
Drywall Anchor
TT
M5 x 65 mm Screw
CH
Complete hardware
PART #
00LWSGDS-A
00LWSGDS-B
00LWSGDS-C
00LWSGDS-D
00LWSGDS-E
00LWSGDS-F
00LWSGDS-G
00LWSGDS-H
00LWSGDS-AA
00LWSGDS-BB
00LWSGDS-CC
00LWSGDS-DD
00LWSGDS-EE
00LWSGDS-FF
00LWSGDS-GG
00LWSGDS-HH
00LWSGDS-II
00LWSGDS-JJ
00LWSGDS-KK
00LWSGDS-LL
00LWSGDS-MM
00LWSGDS-NN
00LWSGDS-OO
00LWSGDS-PP
00LWSGDS-QQ
00LWSGDS-RR
00LWSGDS-SS
00LWSGDS-TT
00LWSGDS-CH
12
Publicidad
