KitchenAid KSB655 Manual De Instrucciones página 12

Using the Blender
Before Use
NOTE: While the Blender is on or the
PULSEMODE indicator light is blinking:
- Do not interfere with blade movement
- Do not remove pitcher or accessory jar lid
Operating the Blender
The KitchenAid _ Blender has five speeds:
STIR,CHOP,MIX, PUREEand LIQUEFY.In
addition, it also features CRUSH ICEand
PULSEMODE.
1. With convenient one-step operation,
this unit will operate only when a
speed selection button is pressed.
2. Before operating the Blender, make
sure the pitcher or accessory jar is
properly secured in the locking collar
and assembly is positioned on the
Blender base.
No
lap
4. Pressthe desired speed button for
continuous operation at that speed.
The red indicator light above the
selected speed will stay lit. You may
change settings without stopping the
unit by pressing a new speed button.
IMPORTANT: If blending hot foods or
liquids, remove the center ingredient cup.
Operate only on STIRspeed.
B. To turn off the Blender, press OFR
The Off button will stop any speed
and deactivate the Blender at the
same time.
6. Before removing the pitcher or
accessory jar assembly, unplug the
power cord.
CRUSH ICE
Your KitchenAid '_ Blender offers a CRUSH
ICEfeature. When selected, the Blender
will automatically pulse at staggered
intervals at the optimal speed for crushing
ice or other ingredients.
1. Before operating the Blender, make
sure the pitcher or accessory jar
assembly is properly positioned on the
Blender base.
NOTE: If a gap exists between the
locking collar and the base, the pitcher or
accessory jar might not be locked into the
locking collar or the collar is not positioned
properly on the Blender base. See Blender
Assembly, page 8 for further instructions.
2. Put ingredients into the pitcher or
accessory jar and firmly attach lid.
3. PressCRUSHICE.The indicator light will
stay lit. The Blender will automatically
pulse at staggered intervals.
NOTE: If a gap exists between the
locking collar and the base, the pitcher
or accessory jar might not be locked into
the locking collar or the assembly is not
positioned properly on the Blender base.
See Blender Assembly, page 8 for further
instructions.
3. Put ingredients into the pitcher or
accessory jar and firmly attach lid.
10