Uline H-840U-10 Manual Del Usuario página 2

Diagram 1
BACK PANEL ASSEMBLY
NOTE: DO NOT tighten bolts until instructed to.
1. Place the ladder stile (D) on the floor. Be sure to
assemble on a protective surface so the finish does
not get damaged.
2. Bolt back panel (F) to the insides of lugs 1 with two
3/8-16 x 1¼" hex head cap screws and self-locking
nuts. (See Diagram 1)
PAGE 2 OF 9
ASSEMBLY
Lug 1
F
Lug 2
Lug 3
D
E
Brake Housing
BOTTOM BAR INSTALLATION
1. Bolt bottom bar (E) to the insides of lugs 3 with two
3/8-16 x 1¼" hex head cap screw, and self-locking
nuts. (See Diagram 1)
2. Bolt other end of bottom bar (E) to the inside of
lug 2 on back panel. (See Diagram 1)
3. Repeat on opposite side with remaining bottom bar.
4. If rubber tips have not been installed prior to
shipping, slip rubber tips onto the ends of the legs.
NOTE: Brake housing must be on the inside
of the bottom bars (E) with the large opening
facing away from the stile. (See Diagram 1)
1223 IH-840U-10