Publicidad
Idiomas disponibles
Idiomas disponibles
Diagram 2
C
Rear
Handrail
Bar
HANDRAIL INSTALLATION
CAUTION: NEVER climb a ladder that is not
completely assembled.
1.
Install left handrail (A) into the rear stile tubes. Use
the rubber mallet as needed for mating parts.
(See Diagram 2, Step 1)
2. Detach handrail brackets that are shipped attached
to handrail.
3. Clamp side handrail to outside of stile tubes using
detached handrail brackets and 3/8-16 x 2" hex
head cap screws (H.H.C.S.), gray bushings and self-
locking nuts. (See Diagram 2, Step 2)
4. Repeat step 1 through 3 with right handrail (B).
5. Detach rear handrail bar (C) from handrail.
6. Insert notched bushing into each end of rear
handrail bar (C).
7.
Position rear handrail bar between mounting holes
of side handrails (A) and (B). Attach using two
1/4-20 x 1¼" hex head cap screws.
(See Diagram 2, Step 3)
NOTE: Tighten all handrail bolts.
PAGE 3 OF 9
ASSEMBLY CONTINUED
1/4-20 x 2¾"
H.H.C.S.
Side
Handrail
Notched
Bushing
STEP 3
Stile
Tubes
Tube Cap
Handrail
Rear Stile
Tube
A B
STEP 1
D
LEVELING
1.
Stand ladder upright on level surface.
2. Weight ladder to compress casters making sure
ladder rests level on all four legs.
3. Tighten all bolts.
1-800-295-5510
uline.com
Handrail
Handrail
Bracket
3/8-16 x 2"
H.H.C.S.
Gray
STEP 2
Bushing
3/8-16
Self-Locking Nut
1223 IH-840U-10
Publicidad
