Publicidad
Idiomas disponibles
Idiomas disponibles
the affected areas with fresh water and seek
medical attention!
WEAR PROTECTIVE GLOVES!
Leaked or damaged batteries/re-
chargeable batteries can cause burns
on contact with the skin. Wear suitable protec-
tive gloves at all times if such an event occurs.
In the event of a leakage of batteries/recharge-
able batteries, immediately remove them from
the product to prevent damage.
Only use the same type of batteries/rechargeable
batteries. Do not mix used and new batteries/
rechargeable batteries.
Remove batteries/rechargeable batteries if the
product will not be used for a longer period.
Risk of damage of the product
Only use the specified type of battery/recharge-
able battery!
Insert batteries/rechargeable batteries according
to polarity marks (+) and (-) on the battery/
rechargeable battery and the product.
Use a dry lint-free cloth or cotton swab to clean
the contacts on the battery/rechargeable battery
and in the battery compartment before inserting!
Remove exhausted batteries/rechargeable bat-
teries from the product immediately.
Start-up
Note: Remove all packaging materials from the
product.
Removing the insulating strip
Note: The product is supplied with batteries
already installed.
Remove the insulating strip from the battery
compartment
before first use.
5
Inserting/replacing batteries
Open the battery compartment cover
insert three batteries type AA (LR6) in the battery
compartment
(Fig. B). Be sure the polarity
5
14 GB/IE
is correct. This is indicated in the battery com-
partment
Close the battery compartment cover
wards.
Switching on and off
The battery cover
Press this push button repeatedly to successively
set the product to TIMER, ON and OFF.
In timer mode the product glows permanently for
6 hours and will be followed by a subsequent
pause of 18 hours. Afterwards, the product will
light up again at its designated turn on time for 6
hours followed by a subsequent pause of 18 hours.
In ON mode, product will light until switched
off by pressing the push button
Using the suction cup hanger
Clean the desire smooth surface (e.g. Glass)
before place the suction cup hooks
light chain on hook(s) and fixed securely. The
product is ready for use.
Note: Suction products rely on well prepared clean,
dry surface.
Not recommended for porous surface porcelain,
marble tiles, textured or treated tiles.
Note: Do not use suction products above beds or
position where failure could cause injury.
Cleaning
Use a feather duster to clean the product.
Disposal
The packaging is made entirely of recyclable materials,
which you may dispose of at local recycling facilities.
and
Observe the marking of the packaging
3
materials for waste separation, which
b
a
are marked with abbreviations (a) and
.
5
has a push button
3
2
after-
3
.
2
.
. Put the
4
Publicidad
