Publicidad
Idiomas disponibles
Idiomas disponibles
Safety information
• Always keep the Obstacle Sensor Window
and the Cliff Sensor Window clear.
- If foreign matter accumulates, sensors
may malfunction.
• Do not store the Jet Bot in a car.
• Be careful that the LiDAR sensor is not
exposed to a direct light such as sun light,
infrared light, etc.
- The direct light can affect the performance
of the LiDAR sensor.
• When carrying the Jet Bot, be careful not to
let it drop.
- The impact from the drop can affect the
operation or performance of the LiDAR
sensor.
• Do not look at the transmitting part (a laser)
of the revolving LiDAR sensor horizontally.
• Be careful not to insert a tool such as a
chopstick into the revolving LiDAR sensor.
Otherwise, the LiDAR sensor may work
abnormally or malfunction.
• Before cleaning, remove objects such as a
thin electric wire (1 cm or less), socks, etc.
on the floor as they can be caught in the
Jet Bot's brush or Driving Wheels.
• If oil such as cooking oil is on the floor, the
Jet Bot may become stationary because the
floor is slippery. Remove the oil first before
cleaning with the Jet Bot.
14
English
REGULATORY NOTICE
1. FCC Notice
WARNING
• Any changes or modifications not expressly
approved by the party responsible for
compliance could void the user's authority
to operate the equipment.
• This device complies with Part 15 of FCC
Rules. Operation is Subject to following two
conditions:
1 This device may not cause harmful
interference, and
2 This device must accept any interference
received including interference that cause
undesired operation.
• For product available in the USA/Canada
market, only channel 1 ~ 11 can be operated.
Selection of other channels is not possible.
FCC STATEMENT:
• This equipment has been tested and found
to comply within the limits for a Class B
digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation.
• This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there
is no guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can
be determined by turning the equipment
off and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the
equipment and receiver
Publicidad
