Publicidad
Idiomas disponibles
Idiomas disponibles
FHR 2040 – FHR 2045
These instructions for use belong to the appliance and must be kept in a safe place. When changing
owners, these instructions must be surrendered to the new owner!
SAFE POSITIONING
The heater must not be located immediately below a socket outlet.
Only use the fan heater when it is standing in a horizontal position. Do not place the heater on
instable surfaces, such as bed, carpets etc. and do not use the heater on uneven position, where
the heater can tip over – otherwise there is a risk of fire.
For your own safety and that of others: water and electricity are a dangerous combination! Do not
use this heater in a bathroom or near a swimming pool. Ensure that the appliance cannot fall into
water (bath wash basin, shower cubicle, etc.)
Please read also the safety information before using.
Do not use the heater on extremely deep-pile carpets!
HOW TO USE THE HEATER
1. Connect on the power.
2. Spin the switch, choose the suitable one: fan (2), 1000W (3) or 2000W (4)
3. Turn the Thermostat to choose the temperature. The heater begins to work
Overheating safety device
To prevent damage and risks due to overheating, the built-in overheating safety device cuts off the
power as soon as the heating elements become too hot. If this should happen:
First ensure that it was not the thermostat which has switched off the heater. Set the thermostat to
maximum position. If the heater does not switch on, the safety device has been activated.
Remove the mains plug from the wall socket.
-
Let the heater cool down for 30 minutes.
-
Check if the heater had been placed correctly.
-
Check if anything is obstructing the air flow.
-
If necessary, clean the grilles with a vacuum cleaner.
-
15
Publicidad
