Publicidad
Idiomas disponibles
Idiomas disponibles
MAIN ASSEMBLY INSTALLATION
WARNING:
To avoid the risk of electrocution confirm the electrical supply has been disconnected or switched off before continuing any installation work.
Fig 12
A
A
B
The power connector (B, in Fig
12) will carry power from the rear
housing to the main housing once
the assemblies are fully seated.
The main assembly will attach to
the rear housing assembly by the
four screws previously removed
(Fig 5 & 6). Two snap hooks (A,
in Fig 12) will hold the main and
rear assemblies together until the
screws can be installed.
RE-INSTALLING FILTERS
IMPORTANT:
Make sure all plastic wrap is removed from filters.
Fig 16
Make sure filters are in correct
inserted into filter frame (Fig 16).
Fig 20
will be visible through the lens,
indicating the unit is operational
(Fig 20). The power light indicator
will flash once a second.
Fig 13
Carefully align the main assembly
with the rear housing assembly.
Slowly press into place until snap
is heard, and there is no gap
between the assemblies (Fig 13).
The unit should now support its
own weight.
Fig 17
IMPORTANT
detection area aligns with window
in filter frame (Fig 17).
Fig 14
1
2
Install four screws (previously removed) to secure main assembly to rear
housing assembly (Fig 14 & 15).
Fig 18
Open front panel by pressing
latches on both sides of unit. Allow
door to open fully. Insert filters
– IMPORTANT
detection window is aligned in
upper right corner (Fig 18).
LOCKING ACCESS PANEL
Fig 21
Fig 15
3
4
Fig 19
Close front panel by pressing
firmly until both sides latch closed
(Fig 19).
To restrict access to the control panel
and filters the unit can be locked. To
lock, insert the key provided and
rotate clockwise ¼ turn (Fig 21).
5
Publicidad
