Publicidad
Idiomas disponibles
Idiomas disponibles
Operations & Parts Manual
Oil and Water Extractor is Important for Spray Gun
Achieving a fine spray finish without the use of a good oil and
water extractor is virtually impossible. It eliminates blistering
and spotting by keeping air free of oil and water, and it gives
precise control of the gun.
HVLP Gravity Feed Spray Gun
1.
Thoroughly mix and thin paint in accordance with the
paint manufacturer's instructions. Most materials will
spray readily if thinned properly.
2.
Stain material through cheese cloth or a paint strainer.
3.
Fill the canister about 3/4 full and start the air
compressor.
4.
Set up a piece of cardboard or other scrap material to use
as target and adjust for best spray pattern.
5.
Test the consistency of the material by marking a few
strokes on a cardboard target. If material still appears too
thick, add a small amount of thinner. THIN WITH CARE!!
Do
not
exceed
recommendations.
Fill the canister about 3/4 full, DO NOT fill the canister too
full.
FAN DIRECTION
The direction of the fan (horizontal or vertical) can be changed
by loosening the lock ring and turning the air cap 90 degrees.
Hand tighten lock ring after adjustment.
PATTERN ADJUSTMENT
Adjust air pressure with the trigger pulled and air control knob
fully open. If reduced air pressure is desired for some areas of
the spray job, use the air compressor regulator or air control
knob to reduce pressure as necessary.
Air
Control
Knob
Increase
Air Flow
paint
manufacturer's
Decrease
Air Flow
Set pattern size to desired shape.
For full pattern, open pattern control knob by turning
counterclockwise. For a round pattern, turn patter control knob
clockwise.
Turn fluid control knob fully clockwise until closed.
Do not fill the canister too full.
Dual Action Sander
thinning
Regulator to adjust speed.
Die Grinder
Model No. CAT827
Fluid control knob
Pattern control knob
5
Publicidad
