Husqvarna TS 142L Manual De Usuario página 15

CAUTION:
the warm engine can cause burn
damage to the grass. To prevent burn
damage , to the grass, always stop the
engine when you stop the product on
grass areas.
1. Push down on the brake pedal (A) fully until the
product stops fully.
2. Disengage the cutting deck. Refer to
and disengage the cutting deck on page 16 .
3. Put the throttle control in the slow position and
let the engine operate at idle speed for some
minutes.
4. Put the cutting deck in the transport position.
To set the cutting deck in transport
Refer to
position or mow position on page 14 .
5. Turn the ignition key to the "STOP" position and
remove the ignition key from the ignition.
To use the throttle control
The operating efficiency of the engine decreases
when the engine operates at less than full speed.
Full speed gives the best mower performance.
• Set the throttle control (A) to the "FULL" position
to operate the engine at full speed.
A
To use the choke control
Note:
Use the choke control to start a cold engine.
Do not use the choke control to start a warm engine.
1958 - 002 - 12.10.2022
The exhaust gas from
A
To engage
A
1. Pull the knob (A) out to engage the choke
control.
2. Push the knob (A) slowly to disengage the choke
control.
To use the cruise control
Only use the cruise control for forward travel on
smooth, straight surfaces. The cruise control will
disengage automatically if the conditions for cruise
control become unsatisfactory.
1. Push the forward drive pedal (B) down. Keep the
forward drive pedal in a position that gives the
correct speed for the terrain.
A
2. Pull the cruise control lever (A) up and hold it
while you release the forward drive pedal.
3. Release the cruise control lever to engage the
cruise control.
4. Push the brake pedal or tap on the forward drive
pedal to disengage the cruise control.
To use the headlight
• Push the power switch to position (A) to make
the headlight come on.
B
• Push the power switch to position (B) to make
the headlight go off.
B
A
15